User manual HILTI TE 18-M

[. . . ] EC declaration of conformity Page 15 16 18 18 19 22 22 24 25 25 26 26 Operating controls and parts 1 @ Chuck ; Function selector switch = Control switch % Switch lock & Front grip surface ( Rear grip surface en 1. General information 1. 1 Safety notices and their meaning DANGER Draws attention to imminent danger that could lead to serious bodily injury or fatality. WARNING Draws attention to a potentially dangerous situation that could lead to serious personal injury or fatality. CAUTION Draws attention to a potentially dangerous situation that could lead to slight personal injury or damage to the equipment or other property. [. . . ] 5. 1. 5 Service a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. 5. 2 Additional safety precautions 5. 2. 1 Personal safety a) Wear ear protectors. Exposure to noise can cause hearing loss. b) Use auxiliary handles supplied with the tool. Loss of control can cause personal injury. c) Always hold the power tool securely with both hands on the grips provided. Keep the grips dry, clean and free from oil and grease. e) Improve the blood circulation in your fingers by relaxing your hands and exercising your fingers during breaks between working. f) Always lead the supply cord and extension cord away from the power tool to the rear while working. This helps to avoid tripping over the cord while working. 5. 2. 2 Power tool use and care a) Secure the workpiece. This presents a serious risk of electric shock. a) The user and any other persons in the vicinity must wear suitable eye protection, a hard hat, ear protection, protective gloves and breathing protection while the power tool is in use. 21 6. Before use 6. 1 Use of extension cords and generators or transformers Please refer to section 2 "Description". en 7. 7. 1. 3 Removing the chuck 4 CAUTION Wear protective gloves when changing the chuck. Disconnect the supply cord plug from the power outlet. Pull the chuck sleeve forward and hold it securely. Remove the chuck by pulling it away from the power tool. 7. 1. 4 Fitting the chuck 5 CAUTION Wear protective gloves when changing the chuck. Disconnect the supply cord plug from the power outlet. Grip the chuck sleeve, pull it forward and hold it securely in this position. Slide the chuck onto the guide tube from the front and then release the sleeve. 7. 2. 1. 1 Chisel position adjustment CAUTION Do not work in this position. [. . . ] Have the supply cord and plug checked by an electrical specialist and replaced if necessary. Allow the power tool to warm up to the minimum operating temperature. See section: 7. 2. 1 Chiseling 6 Use an extension cord with an adequate conductor cross section. (Please refer to "Before use". ) Press the control switch as far as it will go. [. . . ]