User manual HILTI TE-22

[. . . ] Follow instructions for lubricating and changing accessories. Disconnect tools When not in use; before servicing; when changing accessories such as blades. bits, wheels, cutters, etc. use only extension cords marked "Suitable for use with outdoor appliances store indoors when not in use". - environment Don't expose power tools to rain. [. . . ] Remove adjusting keys and wrenches Form a habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. 15. Avoid accidental starting Don't carry plugged-in tool with finger on switch. Servicing When servicing use only identical reolacement oarts hazardous or result in damage to the tool. - - 5. Don't force tool It will do the iob better and safer at the rate for which it was designed. 6. Use right tool Don't force a small lool or attachment to do the job of a heavy-duty tool. 11. Don't overreach Keep proper footing and barance at all times. Maintain tools with care Keep tools sharp and clean for 't7. Outdoor Use Extension Cords When tool is used outdoors, Grounding This tool should be grounded while in use to protect the ooerator from electric shock. The tool is equipped with an approved three-conductor cord and three-prong grounding type plug to fit the proper grounding type receptacle (figure A). The green (or green and yellow) conductor in the cord is the grounding wire. connect the green (or green and yellow) wire to a live terminal. An adaptor (figure B) is available for connecting the plug to a two prong receptacle. The green-colored rigid "ear" or lug extending B Grou ndgd outlet box outlt box 4N Grounding blade Nn Grou nding blade from the adaotor must be connected to a oermanent ground (such as to a properly grounded outlet box). ;@N Adapter Grounding blade is longest of the 3 blades Caution The metal parts of the drill may be made live if the tool drills into wiring. Only the insulated handles of the TE22 should be contacted when drilling into a wall or other concealed soace. Use of TE-D-SD Setting Tool with HDI Anchors 1. Drill the hole for the HDI anchor and install the anchor into olace. 3. 2. Insert the TE-D-SD Setting Tool into the drill chuck (use same procedure as for a bit). t, lsing both hammering and rotation. Dlace the end of the TE-D-SD Setting Tool into the anchor and "hammer" the plug into the anchor until the setting tool bottoms out on the top of the anchor. The HDI is now "set". Maintenance of bits Because of the operating principle of the TE22, excess operator pressure is not needed. [. . . ] Parts which are found to be defective in material or workmanship will be replaced or repaired without cost other than the cost of shipping and insurance. Under no circumstances will Hilti be obligated for consequential or other damages, losses, or expenses in connection with or by reason of the use or inability to use the tool for any purpose. Servicing All repairs and adjustments to the Hilti TE22 including inspecfion and replacement of the brushes, swiich, and power cord, should be performed at a Hilti Repair Center. When servicing use only identical replacement parts, as shown on the oarts list, Preventive maintenance Check for worn or frayed cord. [. . . ]