User manual HILTI TE 70

[. . . ] TE 70-ATC / TE 70 Bedienungsanleitung Operating instructions Mode d'emploi Manual de instrucciones Istruzioni d'uso Gebruiksaanwijzing Brugsanvisning Bruksanvisning Bruksanvisning Käyttöohje Manual de instruções Lietoßanas pamåcîba Instrukcija Kasutusjuhend de en fr es it nl da no sv fi pt el lv lt et 1 1 2 3 7 4 6 5 8 9 + 2 3 4 1 1 4 3 2 5 2 5 4 5 6 1 5 4 1 3 2 6 1 7 3 2 5 2 7 8 6 2 4 8 5 a. m 7:30 07 9 1 2 1 4 2 8 6 2 3 3 TE 70ATC / TE 70 combi hammer It is essential that the operating instructions are read before the power tool is operated for the first time. Always keep these operating instructions together with the power tool. Ensure that the operating instructions are with the power tool when it is given to other persons. Contents 1. EC declaration of conformity Page 15 16 18 19 20 22 22 25 26 27 27 28 1 These numbers refer to the corresponding illustrations. [. . . ] Release the side handle clamping band by turning the handle counterclockwise. 7. The user must be prepared for sudden sticking and stalling of the insert tool. CAUTION Use clamps or a vice to hold the workpiece securely. CAUTION In accordance with the applications for which it is designed, the power tool produces a high torque. Always use the side handle and hold the power 22 CAUTION The collar at the front end of the gearing section is not to be used as a gripping surface. 7. 1 Preparing for use CAUTION Wear protective gloves when changing insert tools as the insert tools get hot during use. Disconnect the supply cord plug from the power outlet. Check that the connection end of the insert tool is clean and lightly greased. Check that the sealing lip of the dust shield is clean and in good condition. Clean the dust shield if necessary or have it replaced if the sealing lip is damaged. Push the insert tool into the chuck and rotate it while applying slight pressure until it engages in the guide grooves. Push the insert tool further into the chuck until it is heard to engage. Check that the insert tool has engaged correctly by pulling it. Disconnect the supply cord plug from the power outlet. Open the chuck by pulling back the insert tool locking sleeve. 7. 2 Operation CAUTION Switch the power tool on only after bringing it into the working position. CAUTION Do not operate the function selector switch while the motor is running. 7. 2. 1 TPS theft protection system (optional) NOTE The power tool may be equipped with the optional theft protection system. If the power tool is equipped with this feature, it can be unlocked and made ready for operation only through use of the corresponding TPS key. Plug the supply cord into the power outlet. The yellow theft protection indicator LED blinks. The power tool is now ready to receive the signal from the TPS key. Hold the TPS key or the TPS watch strap buckle against the lock symbol. [. . . ] The control switch is not pressed fully. The "Reduced power" (50% power) button is engaged. The voltage provided by the electric supply is too low. 26 Fault The drill bit doesn't rotate. Possible cause The function selector switch is not engaged or is in the "Chiseling" or "Chisel adjustment" position. The side handle is not fitted correctly. Remedy When the motor has stopped, move the function control switch to the "Drilling without hammering" or "Hammer drilling" position. [. . . ]