User manual HILTI TE 706-AVR

[. . . ] TE 706 / TE 706-AVR Bedienungsanleitung Operating instructions Mode d'emploi Istruzioni d'uso Gebruiksaanwijzing Manual de instruções Manual de instrucciones Brugsanvisning Käyttöohje Bruksanvisning Bruksanvisning Kasutusjuhend Lietoßanas pamåcîba Instrukcija de en fr it nl pt es da fi no sv el et lv lt 282211 *282211* 1 3 2 1 4 7 6 5 10 9 8 11 2 3 1 3 1 2 2, 4 4 1 5 10 6 4 5 1 3 2 3 2 8 9 7 6 7 1 2 TE 706/TE 706-AVR breaker It is essential that the operating instructions are read before the tool is operated for the first time. Always keep these operating instructions together with the tool. Ensure that the operating instructions are with the tool when it is given to other persons. 1. General information 1. 1 Safety notices and their meaning -CAUTIONDraws attention to a potentially dangerous situation that could lead to minor personal injury or damage to the equipment or other property. [. . . ] with a metal detector) to ensure that no concealed electric cables or gas and water pipes are present. External metal parts of the tool may become live if, for example, an electric cable is damaged inadvertenly. This presents a serious risk of electric shock. b) Check the condition of the supply cord and its plug connections and have it replaced by a qualified electrician if damage is found. Check the condition of the extension cord and replace it if damage is found. Do not touch the supply in the event of it suffering damage while working. Disconnect the supply cord plug from the socket. Damaged supply cords and extension cords present a risk of electric shock. 5. 2. 3 Work area a) Ensure that the workplace is well lit. b) Ensure that the workplace is well ventilated. Poorly ventilated workplaces may be injurious to the health due to exposeure to dust. 5. 2. 4 Personal protective equipment The user and any other persons in the vicinity must wear suitable eye protection, a hard hat, ear protection and protective gloves when the tool is in use. Push the insert tool into the chuck and rotate it while applying slight pressure until it engages in the guide grooves. Push the insert tool further into the chuck until it is heard to engage. Check that the insert tool has engaged correctly by pulling on it. Turn the chisel adjustment and locking switch to the "Rotate chisel" position. Rotate the chisel to the desired position. Turn the chisel adjustment and locking switch to the "Lock chisel" position. Rotate the chisel until it engages (24 click-stop positions per revolution). 7. 1. 3 Removing the insert tool -CAUTION­ The insert tool may become hot during use. Wear protective gloves when changing insert tools. 1. Unplug the supply cord form the power source. [. . . ] The power tool should be repaired at a A fault has occurred in the tool. The tool does not achieve The power level selector switch is not Bring the power level selector switch to the correct position. Use an extension cord of permissible The extension cord is too long or has length and of adequate cross section an inadequate cross section. Connect the tool to a different power The voltage provided by the electric source. [. . . ]