User manual HISENSE HTZ60235IC

[. . . ] Safety and warning information_ __ _ _ _ _ 2 Installing your new appliance_ _ _ _ _ _ _ This appliance is in accordance with the following EU guidelines:2014/35/EU and 2014/30/EU and 2009/125/EC and EC. For your safety and correct usage, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to make sure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and be sure that they remain with the appliance if it is moved or sold, so that anyone using it throughout its life, will be properly informed on its usage and safety notices. [. . . ] Change handle to left, install it as show figure . Detach door stopper and limit block and then install door stopper and limit block to right as show figure and . Just remount to the step 5, change part to right and part to left and then fix them with screws . Take off the part , place it at side for use as show figure . Move the freezer door to appropriate position, adjust part and door, then fix part by screws as show figure . (Please hold upper door by hand when installing). Fix the part as show figure (which is in the plastic bag) . Reverse part by 180°and install it onto the left corner of the door as show figure . ( which was taken down in step 2) Left Lower hinge part Front foot fixed board Adjustable bottom feet part special flange self-tapping screw 6. Screw out lower hinge axis, change it to the near hole site as the picture below, and then screw up and mount washer as the picture below. Finally install part and part (both of which are taken down in step 2) in the refrigerator body as the picture below. View of the appliance Note: Due to constant improvement of our products, your refrigerator may be slightly different from this instruction manual, but its functions and using methods remain the same. To get more space in the freezer, you can remove drawer(except lower freezer drawer), installation bracket and integrative ice maker/twistable ice tray. Note: To get the best energy efficiency of this product, please place all shelves, drawers and baskets on their original position as the illustration above. All functions and controls of the unit are accessible from a control panel conveniently located on the roof refrigerator body. A display circuit board allows easy configuration of features and settings in a simple and intuitive manner. When the refrigerator is energized, all the pilot lights will turn on for 3 sec and you will also heard a long sound of "beep". The display board consists of four buttons and eight pilot lights. You will heard a short sound of "beep" when you press the button. Controlling the temperature We recommend that when you start your refrigerator for the first time, the temperature for the refrigerator is set to -18°C. If you want to change the temperature, follow the instructions below. When you set a temperature, you set an average temperature for the whole refrigerator cabinet. [. . . ] Appliance is not Check the fuse or circuit of your power supply, replace if working correctly necessary. Try setting the chamber temperature to a colder level to solve this problem. It is normal that the refrigerator is not operating during the automatic defrost cycle, or for a short time after the appliance is switched on to protect the compressor. Odours from the The interior may need to be cleaned. [. . . ]