User manual HISENSE RB327N4AD2

[. . . ] Bewegliche Regale / Tabletts Various glass, plastic storage shelves or wire trays are incIuded with your appIiance-different models have different combinations and different models have different features. The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. Safety and warning information For your safety and correct usage, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to make sure that all people using the appliance are thoroughly familiar with its operation and safety features. [. . . ] Stop block Self-tapping screw Stop block Self-tapping screw Change screw hole covers on middle cover plate from left to right(as shown in figure below). Unscrew the two special flange selftapping screws which are used for fixing the middIe hinge part, then remove the middle hinge part that hold the Iower door in place. Note:When removing the door, watch for washer(s) between the Iower hinge and the bottom of the lower door that may stick to the door. Lay the refrigerator on soft foam packaging or similar materiaI. Press the right side of the door shelf inwardly, while holding the left side. When the notch of the shelf has been detachesd from the refrigerator door, remove the rack obliquely upwardly. Remove and install the door shelf Warning:The door shelf must not removed and installed by the user!Lf the door shelf is damaged, contact the customer helpline for assistance. To replace the door shelf, the below steps can be followed: control panel Use your appliance according to the following control regulations, your appliance has the corresponding functions as the control panels showed in the pictures below. On hot summer days) and a colder setting can cause the compressor to run Firstly tilt the left side of the door shelf, and make sure the notch has been fastened to the door. Then press the right side inwardly, push it down to the right place. So we do not advise the user set the temperature control knob at"colder" or "cold" in normal. Reason:when the ambient temperature is high, the compressor must run continuously to maintain the low temperature in the appliance. Energy saving tips We recommend that you follow the tips below to save energy. Try to avoid keeping the door open for long periods in order to conserve energy. Ensure the appliance is away from any sources of heat (Direct sunlight, electric oven or cooker etc) Don't set the temperature colder than necessary. Don't store warm food or evaporating liquid in the appliance. Place the appliance in a well ventilated, humidity free, room. please refer to Installing your new appliance chapter. If the diagram shows the correct combination for the drawers, crisper and shelves, do not adjust the combination as this is designed to be the most energy efficient configuration. Hints for fresh food refrigeration Do not place hot food directly into the refrigerator or freezer, the internal temperature will increase resulting in the compressor having to work harder and will consume more energy. Do cover or wrap the food, particularly if it has a strong flavor. [. . . ] Instead, it should be taken to the appropriate waste collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by the inappropriate waste handling of this product. For more detailed information about the recycling of this product, please contact your local council your household waste disposal service, or the shop where you purchased the product. To avoid contamination of food, please respect the following instructions: - Opening the door for long periods can cause a significant increase of the temperature in the compartments of the appliance. [. . . ]