User manual HITACHI POWER TOOLS N3824A ELECTRIC TOOL PARTS LIST

[. . . ] Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. Inside the pack containing this manual, you will also find the guarantee and all the details necessary for installation. If the appliance is levelled correctly, it will be more stable and much less likely to cause vibrations and noise while it is operating, particularly during the spin cycle. If it is placed on carpet or a rug, adjust the feet in such a way as to allow a sufficient ventilation space underneath the wasdher-dryer. [. . . ] To remove the delayed start option, press the button until the display shows the text OFF; the symbol will disappear. Once the START/PAUSE button has been pressed, the time delay may only be decreased. Press the OPTION buttons to customise the wash cycle in accordance with your own requirements. € Press the button to activate the option; the corresponding indicator light will switch on. € Press the button again to disable the option; the indicator light will switch off. If the selected option is not compatible with the selected wash cycle, this incompatibility will be signalled by the flashing of the indicator light and a sound alert (3 beeps); the option will not be activated. If the selected option is not compatible with another option that has been selected previously, the indicator light corresponding to the first option selected will flash and only the second option will be activated; the indicator light corresponding to the button will remain lit in a constant manner. The corresponding indicator light remains lit in a fixed manner and the porthole door locks (the LOCK indicator light illuminates). The actual duration can vary according to factors such as water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected. (*) Note: 10 minutes after the START, the machine will recalculate the time remaining until the end of the wash cycle on the basis of the load inside it; this value will then be shown on the display. For all Test Institutes: 1) Test wash cycle in compliance with regulation EN 50229: set wash cycle with a temperature of 60°C. Measuring out the detergent carefully will avoid wastage and help to protect the environment: although they are biodegradable, detergents still contain ingredients which alter the balance of nature. We recommend the following: • use powder detergents for white cotton garments and pre-washing. € use liquid detergents for delicate cotton garments and for all low-temperature wash cycles. € use gentle liquid detergents for wool and silk garments. The detergent should be poured into the relevant compartment - or the dispenser placed directly inside the drum - before the wash cycle begins. In the latter case, it will not be possible to select the Cottons with pre-wash cycle. Do not use hand washing detergents because these create too much foam. Preparing the laundry • Shake out the garments before loading them into the machine. € Divide the laundry according fabric type (symbol on the washing instruction label) and colour, making sure you separate the coloured garments from the white ones; • Empty all pockets and check the buttons; • Do not exceed the values listed in the “Table of wash cycles”, which refer to the weight of the laundry when dry. This means that all washable wool garments may be washed in the Washer-dryer, even those which state “hand wash only” on the label when washed in accordance with the instructions for the wool cycle. Ultradelicates: use programme to wash very delicate garments having strasses or sequins. [. . . ] eN Problem: The Washer-dryer does not switch on. Possible causes / Solutions: • The appliance is not plugged into the socket fully, or not enough to make contact. • • • • The door is not closed properly. The START/PAUSE button has not been pressed. [. . . ]