User manual HITACHI POWER TOOLS P100F ELECTRIC TOOL PARTS LIST

[. . . ] The exclamation point within a triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION:  REDUCE THE RISK OF ELECTRIC TO SHOCK, DO NOT REMOVE COVER. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user’s authority to operate this equipment. NOTE: This equipment has been tested and found to comply with the limits for Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] d. When the product does not operate properly as described in the operating instructions.  o not touch the controls other than those described in the operating instructions. Improper adjustment of controls D not described in the instructions can cause damage, which often requires extensive adjustment work by a qualified technician. e. When the product has been dropped or damaged. f.  hen the product displays an abnormal condition. Any noticeable abnormality in the product indicates that the product W needs servicing. 15.  eplacement parts — In case the product needs replacement parts, make sure that the service person uses replacement R parts specified by the manufacturer, or those with the same characteristics and performance as the original parts. Use of unauthorized parts can result in fire, electric shock and/or other danger. 1 S 6.  afety checks — Upon completion of service or repair work, request the service technician to perform safety checks to ensure that the product is in proper operating condition. 1 W 7.  all mounting — When mounting the product on a wall, be sure to install the product according to the method recommended by the manufacturer. 1 H 8.  eat sources — Keep the product away from heat sources such as radiators, heaters, stoves and other heat-generating products (including amplifiers). -  emember that children can become excited while watching a program, especially on a “larger than life” monitor. Care R should be taken to place or install the monitor where it cannot be pushed, pulled over, or knocked down. -  are should be taken to route all cords and cables connected to the monitor so that they cannot be pulled or grabbed by C curious children. SAFETY INSTRUCTION -  o not use the monitor where there is a lot of dust, where D humidity is high, or where the monitor may come into contact with oil or steam, as this could lead to fire. -  nsure that the monitor does not come into contact with E water or other fluids. Ensure that no objects such as paper clips or pins enter the monitor as this could lead to fire or electric shock. -  o not place the monitor on top of unstable objects or in D unsafe places. Do not allow the monitor to receive strong shocks or to strongly vibrate. Causing the monitor to fall or topple over may damage it. -  o not use the monitor near heating equipment or in places D where there is likelihood of high temperature, as this may lead to generation of excessive heat and outbreak of fire. -  o not use the monitor in places where it may be exposed to D direct sunlight. -  he AC outlet shall be installed near the equipment and shall T be easily accessible. The Power Cord - Use only the power cord supplied with the monitor. [. . . ] If you tilt the monitor, do not tilt more than 20° up or down. • Mounting the monitor on the wall requires special expertise and the work must be performed by an authorized HITACHI POWER TOOLS dealer. You should never attempt to perform any of this work yourself. Our company will bear no responsibility for accidents or injuries caused by improper mounting or mishandling. [. . . ]