User manual HITACHI POWER TOOLS PDP115A ELECTRIC TOOL PARTS LIST

[. . . ] This appliance is marked according to the European directive 2002/96/EC on waste electrical and electronic equipment (WEEE). 22 FR ES EN IT 3 13 23 33 Dear client, You have just purchased a HITACHI POWER TOOLS range ventilation hood, and we thank you for your purchase. Our research and development teams have designed a new generation of appliances for you, which, because of their aesthetics, functionality, and technological evolution, are truly exceptional products representative of our design experience. Your new HITACHI POWER TOOLS range ventilation hood will harmoniously suit your kitchen and will perfectly combine ventilation performance and ease of use. [. . . ] Never put your hands in the field of action of the cooker hood extractable unit, during handling operations. 25 - MOUNTING THE HOOD Installation must conform to the regulations in force regarding the ventilation of enclosed environments. In France, these regulations are container in the DTU 61. In particular, discharged air must not be channelled into a conduit used for exhaust discharge or discharge from devices that operate with gas or other combustible materials. The use of unused conduits is not permissible without the approval of a qualified technician. - DESCRIPTION OF THE APPLIANCE 26 2/ HOOD INSTALLATION EN A correct installation must be carried out for the good functioning of the downdraft. 1) Make a rectangular hole in the rear part of the furniture’s surface suitable for the dimensions of your hood (Fig. 2) If a gas hob is utilised, the minimum distance from the rear edge of the cooking hob to the downdraft must be at least 50 mm. The DHD1101 model must be installed between two cooking hobs with a maximum of two gas rings each. 3) Before cutting the hole, check that there are no internal structural parts of the furniture or other elements in correspondence to the hood zone that could compromise the correct installation. To permit the installation, verify that the overall dimensions of the hood including its motor are compatible with the furniture. For this mode charcol filters are to be fitted inside the hood. Filtered air will be evacuated in the kitchen trough a duct that conveys the air on a side of the cabinet (Fig. - REMOTE MOTOR INSTALLATION It is possible to install the motor in a remote position from the cooker hood, but it is necessary to order the DHK900 - 989580001 kit. 28 - REMOVAL OF THE FILTER CARTRIDGE - MOUNTING THE CARBON FILTER The cooker hood must be in the open position to install and remove its grease filters and charcoal filters. Remove the front panel by simultaneously pulling on the upper part of each side (Fig. The panel will rotate forwards to make it possible to access the grease filters (Fig. Remove the grease filters to access the carbon filters (Fig. The carbon filters should be changed according to the frequency of downdraft use and in any case, once every 6 months. Warning: the stainless steel panel that protects the filters needs to be repositioned correctly. Incorrect positioning can cause the hood to stop completely. - ELECTRICAL HOOK UP OF THE HOOD USEFUL ADVICE: We recommend fitting the electronic board at a height of at least 10 cm from the ground and at a suitable distance from all heat sources (e. [. . . ] While closing the aspiration panel keeps on working at the speed set up to the height of cm 18 from the cooktop. Below this height the aspiration function is automatically cut out. It is used to extract the aspiration panel up to the maximum height of cm. 30 and to set automatically the first aspiration speed when reaching the height of cm 18 from the cooktop. [. . . ]