User manual HITACHI POWER TOOLS SP18SA ELECTRIC TOOL PARTS LIST

[. . . ] Com/ • If one or more cards in a combination not endorsed by Yamaha are installed in a Yamaha device, electrical shock, fire, or malfunction may occur. Please note that the MY16-AE/AT/TD cannot be used with the following models of Yamaha product that accept option I/O cards (Yamaha MY series and third-party products). Models: 01V, AD824, AW2816, AW4416, D24, DA824, DIO8, DME32, SREV1 • To use the MY16-AE/TD card in a DM2000 or 02R96, the following system software is required: DM2000 Version 1. [. . . ] € Do not attempt to disassemble or modify the card. Do not apply excessive force to board connectors or other board components. (Mishandling of board may lead to shock , fire hazard , or equipment failure. ) • Be sure to disconnect the power cable from the main unit before installing this card (to eliminate shock hazard). CAUTION Failure to observe the following precautions may lead to personal injury, or may result in damage to equipment or other property. € Do not touch the board’s metallic leads (pins) when handling the card. (Pins are sharp and may cause hand cuts. ) • The card is electrostatic-sensitive. Before handling the card, you should briefly touch the main unit’s metal casing with your bare hand so as to drain off any static charge from your body. (class B) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This Class B digital apparatus complies with Canadian ICES-003. cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. €4– Notice When inserting the card, align both sides of the card with the guide rails in the slot of the host device. Ƴ記 カードを取り付けるときは、取り付ける機器のスロットにあるガイドレールに、カードの両端を確実に合わせてください。 –5– MY16-AE The MY16-AE is a 16-channel digital I/O card that supports the AES/EBU format. The following figure shows the connector pin assignment. MY16-AE は、AES/EBU フォーマットに対応した 16 チャンネルのデジタル I/O カードです。 接続端子のピンアサインは、以下のとおりです。 13 1 Signal Hot Cold Data In Ch Data Out Ch 1-2 3-4 5-6 7-8 1-2 3-4 5-6 7-8 Open 9-10 11-12 13-14 15-16 9-10 11-12 13-14 15-16 1 14 2 15 3 16 4 17 5 18 6 19 7 20 8 21 9, 11 GND 10, 12, 13, 22, 23, 24, 25 25 14 Pin SP18SA ELECTRIC TOOL PARTS LIST The SP18SA ELECTRIC TOOL PARTS LIST is a 16-channel digital I/O card that supports the ADAT format. Before installing it, you must set the configuration switches depending on the device that you intend to connect. [. . . ] Before installing it, you must set the configuration switches depending on the device that you intend to connect. If you’re connecting a device other than a DA88, set the switches to “INT:Others. ” There’s a separate switch for each connector. [. . . ]