User manual HITACHI 42PD6700U

[. . . ] Instructions for use GB 42PD6700U Contents Remote Control Buttons . . . . . . . . . . . . . . . . . . . . . . . . . 2 PLASMA TV . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The channel name is set using the or button to display the channel which broadcasts the programme. The start time, end time and date are each set with the digit buttons on the remote control in 24-hour format. The frequency mode determines how often the receiver operates this event and is set with the or button to be either Once, Daily, or Weekly. If an invalid number for the start or end times or the date is entered, Entered time is not valid message appears on the menu. Use the or button to highlight the soundtrack language required and press the OK button. Normal viewing, with the required language soundtrack, can be resumed by pressing the button. If the programme has no alternative language soundtrack broadcast, the Language Menu will not be available, but a message, No Multi Language Available is displayed briefly. RECORDING FROM IDTV Connect your VCR to AV2 via a scart lead. Set the AV2-OUT in the feature menu to DDT, as illustrated on page 21 and described on page 22. Set your TV to standby using the remote control. Set your VCR to correspond with the time set TV Setup To be able to go through TV functions, you can use this item. The digital TV Setup menu screen is accessed from the main menu. Press the button to display the main menu and or button to highlight TV Setup, use - 17 - press the OK button to display TV Setup menu screen. Detailed information about Sound, Picture and Feature menus are in AnalogueTV Menu System section on page 18. Common Interface Press the button to display the Main Menu and use the or button to highlight the Common Interface line and press the OK button. Connect the TV to the mains supply, switch on and then wait for few moments until the card is activated. Some CAMs may require the following set up. Please set the CAM by entering the IDTV menu, Common Interface then pressing the SELECT button. (CAM set up menu is not displayed when it is not required. ) To see the viewing contract information: It is required to subscribe to a pay channel company to view the pay channels of the Digital Terrestrial broadcasting. Obtain the Conditional Access Module (CAM) and the Viewing card by subscribing to a pay channel company, then insert those to the Television using the following procedure. Switch off the TV and unplug from the mains. Insert the CAM, then Viewing Card to the slot that is located in the terminal cover at the left-hand side of the TV (from front view). The CAM should be correctly inserted, it is impossible to insert fully if reversed. The CAM or the TV terminal may be damaged if the CAM is forcefully inserted. Enter IDTV; press the button, then highlight Common Interface and press the OK button. When no module is inserted, No Common Interface module detected message appears on the screen. [. . . ] Connect your equipment to the TV via VIDEO (yellow), AUDIO R (red) and AUDIO L (white) inputs. You must connect the jacks to the input using the same colour. To Connect To S-VHS Input Connect your camera or camcorder S-VHS input at the rear side of the TV. Connect your equipment to the TV via S-VHS input and audio inputs of AV inputs by using S-VHS cables. Connect The Decoder To The Video Recorder Some video recorders have a special Scart socket for decoder. Connect a Scart cable to the Scart socket of - 30 - Aerial Connection Connect Peripheral Equipment - 31 - your decoder and to the special Scart socket of your video recorder. [. . . ]