User manual HITACHI 50EX14BV

[. . . ] IMPORTANT -1- PROJECTION COLOR TV 50EX14BV 55EX15K OPERATING GUIDE TABLE OF CONTENTS IMPORTANT. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY TIPS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PICTURE CAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 ACCESSORIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] To operate your TV, point the remote at the remote sensor of the TV, and press the TV button on the remote. To operate your VCR, point the remote at the remote sensor of the VCR, and press the VCR button. To operate your Cable Box, point the remote at the remote sensor of the Cable Box, and press the CABLE button on the remote. The remote will now control your Cable Box. Click to see the Remote These buttons allow the remote to control your TV, VCR, or Cable Box depending of which mode is chosen, as explained above. , LIGHT BUTTON When you are in a dark room, press this button on the side of the remote to light up the buttons shown in . The light will stay on for about 8 seconds if the light button is not pressed again. These buttons will not appear to light if the room is too bright. PRECODED VCR BUTTONS These buttons always transmit the chosen precoded VCR codes. TV/VCR BUTTON When the remote is in the TV or VCR mode, this is the TV/VCR button. When the remote is in the CABLE mode, this is the A/B button. HOW TO USE THE REMOTE TO CONTROL YOUR TV Click to see Remote POWER button HOW TO USE THE REMOTE TO CONTROL YOUR TV - 18 - Press this button to turn the TV set on or off. If MESSAGE-1 OR MESSAGE-2 is set, it will be displayed when the TV is first turned on. (See page 32. ) RECALL button When you want to check the channel being received, or if it has a stereo (ST) or second audio program (SAP), press the RECALL button. You can also check the time, and if the ON TIME or OFF TIME has been set. (See page 31. ) You can also use the RECALL button to quickly clear many of the other on-screen displays. MENU, ENTER, CURSOR buttons All the on-screen display features can be set or adjusted by using these buttons. The "MENU" button will start or exit the on-screen display. The "CURSOR" buttons will highlight functions or adjust different features. The "ENTER" button will set features to your preference. "CHANNEL SELECTOR" buttons are used to set the time, for channel memory, etc. . CHANNEL SELECTOR buttons "CHANNEL SELECTOR" buttons are used to set the time, for channel memory, etc. Enter two or three numbers to select channels. Enter a "0" first for channels 1 to 9. For channels 100 and higher, press the"1" button, wait until another dash appears next to the channel display on your TV, then enter the remaining two numbers using the number buttons. Channel selection may also be performed by pressing channel up ( ) or down ( ). HOW TO USE THE REMOTE TO CONTROL YOUR TV - 19 - NOTE: The TV may not receive some channels if you are not in the correct AIR/CABLE mode. (See page 25) AVX button The AVX (Auxiliary Video) button will select between the antenna signal and the two sets of video input jacks each time the button is pressed. [. . . ] Replace the old batteries with fresh "AA" size batteries. Exposure of the viewing screen to prolonged direct sunlight or heat may cause the screen to permanently warp, resulting in a distorted picture. RECEPTION PROBLEMS RECEPTION PROBLEMS - 41 - IGNITION NOISE: Black spots or horizontal streaks may appear, picture may flutter or drift. Usually caused by interference from automobile ignition systems, neon lamps, electrical drills and other electrical appliances. GHOSTS: Ghosts are caused by the television signal following two paths. One is the direct path and the other is reflected from tall buildings, hills or some other objects. [. . . ]