User manual HITACHI AXM10E

[. . . ] To clean cabinet and panels when dirty, clean off dirt on the surfaces with a dry cloth. Never use thinner, benzene or alcohol, for these will damage the surface finish. Protect the unit against excessive heat (e. Discs which can be played on the CD player have the following mark on them: Be careful not to damage the power supply cord. [. . . ] The remote control may not be effective in the strong day light. Do not use new and old batteries or different kinds of batteries together. During radio listening (MW), if you operate the remote control extremely close to the sound system, some noise may be produced. The display window lights goes off and only the clock is indicated. oNE TOUCH OPERATION (COMPU PLAY) · Even when the power is set to STANDBY, pressing the button shown below the sound system is automatically turned on, a sound source is chosen, and play begins. function mode CD TUNER AUX Operations When this button is pressed with a CD loaded, CD playback begins. when this button is pressed , the tuner is engaged. A sound source connected to the LINE IN (AUX) terminal can be engaged. When the OPEN/CLOSE button is pressed, the sound source does not switch, but the CD door can open or close. Note: When switching off the power, be sure to press the STANDBY/ON button. DIMMER Button (using the remote control unit) When the power is switched on, pressing this button dims the display window's light. When the button is pressed again, the display window returns to its normal brightness. PRESET EQ Button POPS : More presence in the vocals and midrange ROCK: Powerful sound emphasizing treble and bass CLASSIC: Enriched sound with heavy bass and fine treble JAZZ: Accented lower frequencies for jazz-type music FLAT: Natural sound 46 RESET If operations or displays of this unit are at fault: Many functions of this unit are controlled by microcomputers. Make the units in standby mode and then press the reset switch when operations or displays are still at fault in spite of pressing any buttons. There is also need to set stations again because pressing the reset switch makes the preset stations lost. Press RESET switch inside the unit with a cocktail stick. STEREO/MONO button (using the remote control unit) - Auto mode: When listening to an FM stereo broadcast, set the unit to this mode by pressing the ST/MONO button. The unit enters the seek tuning mode to tune in the nearest station automatically, so the broadcast can be heard. - Manual tuning: Each time the UP or DOWN button is pressed, the unit steps through the current frequency band. When seek tuning to the required station is not possible because the broadcast signal is too weak, press the UP or DOWN button momentarily to perform manual tuning. When the power is set to the STANDBY, or another mode (CD or AUX) is selected, the last tuned frequency is stored in memory. When the power is switched on again and BAND button is pressed, the same station will be turned on. [. . . ] During timer playback, user can get extra 5 minutes of sleep (5 minutes in standby mode) by pressing TIMER/SNOOZE button. Note: In order for the snooze function to operate, the timer on/off interval setting has to be more than 5 minutes. Repeat steps 1 - 4 for each of the other stations, using a different preset button each time. Perform step 2 - 4 after tuning to the required station. [. . . ]