User manual HITACHI C7SB2

[. . . ] Read through carefully and understand these instructions before use. English 1 2 3 4 5 6 7 8 9 0 A B C D E F G H I J K L M N O P Lumber Base Workbench Saw blade Lever (A) Handle Tighten Loosen Scale Wing-bolt Guide When inclined 45° When not inclined Lock lever Box wrench Hexagonal-flange bolt Washer (B) Washer (A) Spindle Wear limit No. Symbols The following show symbols used for the machine. Be sure that you understand their meaning before use. [. . . ] If both hands are holding the saw, they cannot be cut by the blade. b) Do not reach underneath the workpiece. The guard cannot protect you from the blade below the workpiece. c) Adjust the cutting depth to the thickness of the workpiece. Less than a full tooth of the blade teeth should be visible below the workpiece. D) Never hold piece being cut in your hands or across your leg. secure the workpiece to a stable platform. It is important to support the work properly to minimize body exposure, blade binding, or loss of control. E) Hold power tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will also make exposed metal parts of the power tool "live" and shock the operator. F) When ripping always use a rip fence or straight edge guide. This improves the accuracy of cut and reduces the chance of blade binding. G) Always use blades with correct size and shape (diamond versus round) of arbour holes. Blades that do not match the mounting hardware of the saw will run eccentrically, causing loss of control. h) Never use damaged or incorrect blade washers or bolt. The blade washers and bolt were specially designed for your saw, for optimum performance and safety of operation. Never use any abrasive wheels Burst of abrasive wheel cause serious injury of operator or persons around the working area. A) Check lower guard for proper closing before each use. Do not operate the saw if lower guard does not move freely and close instantly. Never clamp or tie the lower guard into the open position. If saw is accidentally dropped, lower guard may be bent. Raise the lower guard with the retracting handle and make sure it moves freely and does not touch the blade or any other part, in all angles and depth of cut. [. . . ] (2) Apply a square to the base and the saw blade and turning the slotted set screw with a slotted-head screwdriver, shift the position of the base to produce the desired right angle. Used D: Remarks CAUTION Repair, modification and inspection of Hitachi Power Tools must be carried out by a Hitachi Authorized Service Center. This Parts List will be helpful if presented with the tool to the Hitachi Authorized Service Center when requesting repair or other maintenance. In the operation and maintenance of power tools, the safety regulations and standards prescribed in each country must be observed. [. . . ]