User manual HITACHI CM1484ME

[. . . ] If VI&o Cmlisa trwk nmkof @le Canpufu, h=. . 2 14MVX Plus User Manual For U. K. Customers THIS PRODUCT IS SUPPLIED WITH A TWO PIN MAINS PLUG FOR USE IN MAINLAND EUROPE. NOTE: ELECTRICAL CONNECTION Your monitor requires an electrical supply of 240 volts ­ 50 Hertz and shfkld be protected by a 5 amp fuse. Your equipment is supplied with a plug incorporating a 5 amp fuse fitted to the mains lead. [. . . ] DO NOT subject the unit to vibrations, dust, or corrosive gases. KEEP IN A WELL VENTILATED PLACE DO NOT cover this monitor or place anything against the sides. Ventilation holes are provided on the cabinet to prevent the temperature from risiig. Ventilation holes are also provided on the bottom and the top of the cabinet. AVOID HEAT Avoid placing the unit in direct sunshine or near a heating appliance. BE CAREFUL OF MAGNETIC FIELDS DO NOT place a magnet, loud speaker system, floppy d~k drive, or anything which will genemte magnetism near the unit. A magnetic field may cause blurred colors or distortion of the displayed pattern. 14MVX PhASUser Manual ~ 5 @PERATmG> Controls Front View Rear View (7) m. (6) (5) (4) (3) (2) (1) J) (8) (1) Power Switch Use this switch to power ON or OFF by pressing it. When the power is ON, green light on the knob turns on to indicate. (2) Contrast Control ((D) Use this to set the foreground brightness cf the screen. (3) Brightness Control (-, , ] Use this to set the background to black. Most of the latest application software utilizes coloured background and this control is usually set at its maximum. (4) Horizontal Size (~] Adjust this control to the preferred horizontal width. If the width is too wide, part of information will be missed from the screen. (5) Horizontal Position (~) Adjust this to place the display at the centre of the screen. 6 14MVX F'hx. sUser Manual (6) Vertical Size [~] Adjust this contxol to the preferred height. (7) Vertical Position [Q 1 Adjust this to place the display at the centre of the screen. (8) Signal Cable Connect the end of the cable to your computer. (9) Power Cord Tn-let Connector Insert proper power cord here. BEFORE CONNECTING TEE MONITOR TO YOUR COMPUTER, MAKE SURE TEE POWER TO TEE MONITOR AND COMPUTER ARE TURNED OFF. 1. Connect the signal cable to your computer's video output comector. `l%ecormector is compatible with IBM PS/2 series computers and VGA standard graphics cards for IBM PC, PC/XT, PC/AT, and compatibles. When you are using the monitor with Apple Macintosh H computer, please obtain an optional converter for comection from your dealer. Connect power cord to the monitor then to wall power outlet. Use the power cord set enclosed with monitor or properly approved power cord, for example, H05 W-F. Power on the monitor then power on your computer. [. . . ] Most of the VGA and Super VGA standard graphics boards available for the PC, PC/AT, PS/2 and EISA bus computers. Apple Macintosh II computer with Macintosh V]deo Card. You have to obtain a 15 pinto 15 pin converter from your dealer. Comector Pin Assignment Pin 9 10 11 12 13 14 15 No. No Pin Ground Ground No Pin Horizontal Sync Vertical Sync No Connection Pin No, 1 Red Video 2 Green Video 3 Blue Video 4 Ground 5 Ground 6 Red &OUd 7 Green Ground 8 Blue Ground 8 14MVX Plus User Manual @PECIFIcATIO@) CRT 14(1 3V) inches diagonal, 0. 28 mm dot pitch, Black B matrix, Silica coated, Short Persistence. [. . . ]