User manual HITACHI CM1584ME

[. . . ] . q =pag 22 page 28 ­ NOTICE = The i~o-ation in tfis d~ument is subject to change without notice. Hitachi assumesno responsibilityfor any errors that may appear in this = doeumenL Colour Monitor `hVIVX Operating Guide Features q The fo]lo~ng features are provided with the HITACHI Monitor 15MVX. range of graphics standard, VGA, colour q Wide compatibility XGA, 8514/A, Super VGA, and Macintosh q II Video Card. Sharp focus and remarkable display quality by new design CRT. [. . . ] A magnetic field may cause blurred colors or distortion of the displayed pattern. lSMVX User Manual 3 i @PERATm@ - Controls Front View [ Rear View u El (7) (1) Power Switch Use this switch to power ON or OFT by pressing it. When the power is ON, green light on the knob turns on to indicate. (2) Contrast Control [0) Use this to set the foreground brightness of the screen. (3) Brighmess Control [~@) Use thii to set the background to black. Most of the latest application software utilizes coloured background and this control is usually set at its maximum. (4) Horizontal Size [~] Adjust this control to the preferred horizontal width. If the width is too wide, part of information will lx missed from the screen. (5) Horizontal Position [~] Adjust this to place the display at the centre of the screen. [m (6) (5) (4) (3) (2) (1) J) u----, R@ (i) 4 15MVX User Manual (6) Vertical Size Adjust this control to the preferred height. (7) Vertical Position Adjust this to place the display at the centre of the screen. (8) Signal Cable Connect the end of the cable to your computer. (9) Power Cord In-let Comector Insert proper power cord here. BEFORE CONNECTING COMPUTER, AND COMPUTER THE MONITOR TO YOUR MAKE SURE THE POWER TO THE MONITOR ARE TURNED OFF. 1. Connect the signal cable to your computer's video output connector. The connector is compatible with IBM P. S. /2 series computers and VGA standard graphics cards for IEM PC, PC/XT, PC/AT, and compatibles. When you are using the monitor with Apple Macintosh II computer, please obtain an optioml converter for connection from your dealer. Hitachi's pantnumber for converter: SC-1 2. Connect power cord to the monitor then to wall power outlet. USE PROPER UL/CSA APPROVED POWER CORD. . . HO5F-F 3. Power on the monitor then power on your computer. When you switch OFF, do the reverse sequence. 4, Adjust front located user controls to obtain right picture size, location, and brightness. [. . . ] Video: 0. 7 Vpp Sync: Separate mV or Composite H/V lTL level or Sync on Oreen at 0. 3 Vpp. Horizontal 30 -- 58 kHz Vertical 5O--1OOHZ Automatically synchronize. Horizontal: Up to 1024 dots Up to 768 lines Vertical: ~ m input Signal Synchronization Resolution Video Band Width Active D~play Area 75 MHz " Horizontal: 260 mm Verticak 195 mm Active display area is changed by the graphics board standard. [. . . ]