User manual HITACHI CM828ET

[. . . ] COLOUR MONITOR (DJ82) CM827ET CM828ET with EasyMenu ! USER MANUAL MANUEL D'UTILISATION BEDIENUNGSANLEITUNG MANUAL DE USUARIO MANUALE DI ISTRUZIONI EasyMenu is HITACHI's On Screen Display function for easy operation. READ THE INSTRUCTIONS INSIDE CAREFULLY. KEEP THIS USER MANUAL FOR FUTURE REFERENCE. For future reference, record the serial number of your colour monitor. SERIAL No. The serial number is located on the rear of the monitor. This monitor is ENERGY STAR® compliant when used with a computer equipped with VESA DPMS. The ENERGY STAR® emblem does not represent EPA endorsement of any product or service. [. . . ] (2) Insert the connector of the power cord to the AC Input of the monitor. (3) Insert the plug of the power cord into a power outlet of the correct voltage. Before inserting the plug of the power cord into a power outlet of the correct voltage, check that the connection portion of the power cord is clean (with no dust). Then firmly insert the plug of power cord into a power outlet to avoid an electrical shock or fire hazard. 1-8 OPERATION ENGLISH Power ON/OFF Press the power switch to switch the power ON or OFF. When the power is ON, the power indicator will light up. NOTE: · First turn on the monitor, then the computer. · After turning OFF the power switch, wait at least 5 seconds before restarting the monitor. If this 5 second delay is not observed, the monitor may operate incorrectly. Input Select This monitor has two input terminals, INPUT1 and INPUT2. This will let you connect two computers simultaneously. When two computers are active, you can switch the input signal by uses the Input Select Button. Every time this button is pushed, the monitor alternately uses the input signal from either INPUT1 and INPUT2 (computer 1 or 2). NOTE: · The Plug and Play function is only supported on INPUT1, and not supported INPUT2. 1-9 Brightness/Contrast Adjustment (1) Press one of the adjustment buttons when the OSD (On Screen Display) is not shown. The OSD function "EasyMenu" will then show the brightness and contrast settings. (2) To adjust these settings, use the adjustment buttons / for brightness, and / for contrast. Brightness/Contrast Menu ENGLISH Other Functions (1) Press the menu button when the OSD is not shown. The OSD function "EasyMenu" will then show the main menu. The EasyMenu has 4 submenus (Screen Menu, Recall Menu, OSD Menu and Colour Menu). You can call these up through the main menu functions . (2) To select the menu function, use the adjustment buttons / . (3) To execute the selected function, use the adjustment buttons / as shown in Table 1-1. Main Menu NOTE: · · · · You can select the OSD language by using the "LANGUAGE SELECT" function of the "OSD MENU". To return to the main menu from any sub menu, simply press the menu button. To clear the OSD, press the menu button at the main menu, then choose the "OSD EXIT" function, or wait for a few seconds, the menu window will disappear automatically. The adjusted settings will be stored automatically. The OSD might flicker on and off for a short period while the OSD is displayed in certain screen settings. Simply move the OSD position a little up or down, and the OSD will become stable. 1 - 10 OPERATION (Continued) Table 1-1. [. . . ] The following industrial standard settings have been pre- programmed by the factory. 1 2 3 4 5 6 7 8 9 10 11 12 13 NOTE: * Input signals with approximately the same frequencies may be regarded as the same signal. * The following horizontal timing conditions are recommended (at sync. for 31 kHz - 55 kHz horizontal frequency: Horizontal front porch should be more than 0. 1 µs. width should be within 1. 0 - 3. 8 µs. [. . . ]