User manual HITACHI CML170SXW

[. . . ] COLOUR LCD MONITOR CML170SXW USER MANUAL MANUEL D'UTILISATION BEDIENUNGSANLEITUNG MANUAL DE USUARIO MANUALE DI ISTRUZIONI READ THE INSTRUCTIONS INSIDE CAREFULLY. KEEP THIS USER MANUAL FOR FUTURE REFERENCE. For future reference, record the serial number of your colour monitor. SERIAL No. The serial number is located on the rear of the monitor. This monitor is ENERGY STAR® compliant when used with a computer equipped with VESA DPMS. The ENERGY STAR® emblem does not represent EPA endorsement of any product or service. [. . . ] This may result in fire and overloading lines will activate the circuit breakers causing data loss or damage to the product. Usage in Humid or Dusty Areas DO not use or store in areas that are humid, dusty or have abundant moisture such as a bathroom. This may cause fire or electrical shock. Moving to Areas of Different Temperature Moving the device to areas that are very different in temperature may cause condensation on the outside and internally. Using the device in this condition may result in fire or electrical shock. Leave the device at the location for a few hours before using. Aluminum Electrolysis Condenser The electrolyte condenser used in the AC adapter has a limited life. If used past the life span (approximately 5 years), replace the AC adapter. Leakage or drying up of the electrolyte liquid may result in fire, electrical shock. This may also cause the device itself to malfunction. Damage to the Display Unit - Liquid may leak out of the display when damaged. If you should touch the liquid, wash your hands thoroughly with water. If the liquid should get into your mouth or eyes, gargle or rinse your eyes and promptly see a doctor for treamenp. - The display unit is made of glass. If the display unit should break, avoid handling the glass fragments. The fragments are dangerous and can cause injury. CAUTION 12 Contact with Metal and Other Edges When moving the computer be careful when coming in contact with the plastic and metal edges. It is possible to be injured. Use in Unstable Places DO not place on sloping or narrow areas that are unstable. The device may drop or fall and cause injury. Display Cable - Arrange the cables so that they are out of the way. If a cable is tripped on, it may cause injury and damage to the connected devices. - DO not place heavy objects on the cable. Additionally, do not place objects that generate heat near the cables. The cable casing may break and cause damage to the devices that are connected. Stand - When adjusting the angle, hold the top left and right edges with both hands and move slowly. Using only one hand may cause it to fall. - DO not place your hand near the stand when adjusting the LCD forward or back. Your fingers may get caught and cause injury. Eyestrain When continuously looking at the display while working, keep the work area lighted at 300 ­ 1000 Luxas. Additionally, for every hour of work, rest 10 to 15 minutes. Continuously looking at the display for prolonged periods will cause accumulated eye fatigue. Disposal of this Product 13 When disposing of this product, confer with the dealer where this product was purchased or refer to laws of the local government or regulations regarding disposal. Electronic Interference If used in the vicinity of other electronic devices, they may interfere with each other's performances. Especially for devices such as radios and televisions, noise may enter their sound reception. If this should happen, try the following: - Place in a location as far away from radios and televisions as possible. - Change the facing of the antenna on the radio or television. [. . . ] Refer to the Standard Timing Table for a listing of modes supported by this LCD Monitor. PROBLEM Picture is unclear and unstable or new colorized 1. Enter PC to "Shut Down Windows" status while you're in a MS-Windows environment. Check the screen to see if any black vertical stripes appear. If there are, use the "Clock" function in OSD menu and adjust (by increment or decrement numbers) until those bars disappear. [. . . ]