User manual HITACHI CMPAD06

[. . . ] Hitachi Plasma Display Tabletop Stand Model CMPAD06 Installation Instructions Thank you for purchasing the Hitachi Plasma Display Table top Stand. To ensure correct usage, please read this instruction manual thoroughly. [. . . ] Turn the base cover over so the underside is facing up. 2. Insert the stand pipes into the base cover. Use the included screws to stabilize the stand pipes. Stand pipe Screws (4 x 8) Stand pipe Base cover Stand attaching to the Plasma Display Normal Installation Step 1. With the plasma display lying flat, insert and secure the two Installation bolts 1 (M8 x 20) in the holes "a" located in the plasma display housing. At this point, tighten these bolts 1 only until the threads are no longer visible when viewed from t he side (you will be unable to attach the display if the bolts are screwed in completely). Installation bolt 1 (M8 x 20) Holes "a" (holes in center of plasma display) Installation bolt 1 Plasma display housing Stop screwing down the bolt when the threads are no longer visible. Plasma display Regarding the stand pipe screw holes when the stand is used as a desktop stand C B A C´ B´ A´ C B A C´ B´ A´ Specifications Normal use With optional speakers attached to both sides of display Screw holes used with stand orientation B, B' Stand attaching to the Plasma Display Step 2. As shown in figure, hook the stand pipe holes onto the screw heads of the installation bolts 1, then slide the stand upwards to the main plasma display until it engages the installation bolts 1 (once put together with the display, the stand will slides no more than 19 mm (3/4 inch)). Pass the installation bolts 2 (M8 x 40) through the stand pipes and tighten the installation bolts securely with the included hexagonal wrench. Tighten the installation bolts 1 securely with the hexagonal wrench provided. Installation bolts 2 (M8 x 40) (Step 3) Notes · Place a sheet or protective cover to protect the display from scratches or damage. · Assemble only with the plasma display lying flat on a table or similar surface. · Insert the bolts vertically in the holes and tighten them, but do not apply excessive pressure that tightens them more than necessary. · Move the stand so that the stand screw holes and the nuts that connect the main display line up correctly. · The display is a 50" model that weighs approximately 40 kilograms (88 lb) and has little depth, making the display very unstable. [. . . ] (Repeat the same steps in the laterally direction to stabilize the assembly to the left and right. ) Use cord and hooks that are available on the market (sold separately). Installation coordinates for screws used to stabilize the stand to the floor 248(9-3/4) 485(19-3/32) 64(2+17/32) 11. 5(7/16) 275(10-13/16) Specificatio Dimensions 566 (W) x 508 (H) x 339 (D) mm (22-5/16 (W) x 20 (H) x 13-3/8 (D) in. ) 4. 0 kg (8. 82 lb) 42. 9 kg (94. 58 lb) (When the 50 inch plasma display is attached) Weight Main material/ Steel sheet Surface treatment ABS Dimensions Diagram Normal use (without optional speakers) Optional speakers attached to both sides of display 1368 Speaker 1218 Speaker 150 774 566 220 508 339 Hitachi, Ltd. Tokyo Japan Digital Media Division 292 Yohida-cho, Totsuka-ku, Yokohama, 244-0817 Japan (045) 866-6302 [. . . ]