User manual HITACHI CPL550E

[. . . ] WARNING This symbol indicates information that , if ignored, could possibly result in personal injury or even death due to incorrect handling. CAUTION This symbol indicates information that , if ignored, could result possibly in personal injury or physical damage due to incorrect handling. Please refer to the pages written following this symbol. NOTE · The information in this manual is subject to change without notice. · The manufacture assumes no responsibility for any errors that may appear in this manual. [. . . ] To quit the operation, press the MENU button on the remote control or keep no operation for 10 seconds. Using the buttons / switches the brightness level of the OSD (On Screen Display). Bright Dark Using the buttons / switches the mode the blank screen. The blank screen is the screen for the temporarily blanking feature (20). It is displayed by pressing the BLANK button on the remote control. MyScreen ORIGINAL BLUE WHITE BLACK OSD BRIGHT BLANK MyScreen is the screen you can register a desired screen. ORIGINAL screen is the existing standard screen. BLUE, WHITE and BLACK are non-patterned (plain) screens in each color. · To avoid remaining as an afterimage, the MyScreen and the ORIGINAL screens will change to the BLACK screen after several minutes. · For the MyScreen, please refer to the item MyScreen (34). 33 ENGLISH ENGLISH Multifunctional settings SCREEN Menu (continued) Item Description Using the buttons / switches the mode the start up screen. The start up screen is the screen displayed when no signal or an unsuitable signal is detected. Use this function for protecting the current MyScreen. START UP My Screen My Screen Lock 34 Multifunctional settings SCREEN Menu (continued) Item Description Using the buttons / turns on/off the message function. TURN ON TURN OFF When the TURN ON is selected, the following message function works. "AUTO IN PROGRESS" while automatically adjusting "NO INPUT IS DETECTED" "SYNC IS OUT OF RANGE" "Searching . . . . " while searching for an input signal "Detecting. . . . " when an input signal is detected The indication of the input signal by changing The indication of the aspect ration by changing . ENGLISH MESSAGE 35 Multifunctional settings OPTION Menu With the OPTION menu, items shown in the table below can be performed. Select an item using the cursor buttons / on the projector or remote control, and press the cursor button on the projector or remote control, or the ENTER button on the remote control to progress, except for the items LAMP TIME and FILTER TIME. Then perform it referring to the following table. Item Description Using the buttons / turns on/off the message function. TURN ON TURN OFF When the TURN ON is selected, detecting no signal automatically cycles through input ports in order of following. Then when an input is found, the projector will stop searching and display the image. If no signal is found, the projector will return to the state before the operation. RGB IN1 RGB IN2 COMPONENT VIDEO S-VIDEO VIDEO Using the buttons / adjusts the time to count down to automatically turn the projector off. 0 minute = DISABLE) AUTO OFF ENABLE AUTO OFF DISABLE 0 1 MENU [RGB] PICTURE IMAGE INPUT SETUP SCREEN OPTION EASY MENU SEARCH AUTO OFF LAMP TIME FILTER TIME SERVICE :SELECT TURN ON 0 0 0 SEARCH AUTO OFF When the time is set to 0, the projector is not turned off automatically. When the time is set to 1 to 99, and when the passed time with a no-signal or an unsuitable signal reaches at the set time, the projector lamp will go off and the power indicator begins blinking. [. . . ] Slowly turn the projector so that the top is facing up. Turn the projector on, and reset the lamp time using the LAMP TIME function of OPTION menu. 3. 4. Claws Screws marked by arrow 5. 6. 9. Tabs Center point of claws Claws NOTE · When the lamp has been replaced after the message of "THE POWER WILL TURN OFF AFTER 0hr. " is displayed, complete the following operation within 10 minutes of switching power on. [. . . ]