User manual HITACHI CPX1402MS

[. . . ] This symbol is intended to alert the user to the presence of important operating and maintenance(servicing) instructions in the literature accompanying the appliance. 3 PRECAUTIONS Safety Should any liquid or solid object fall into the cabinet, unplug the unit and have it checked by qualified personnel before operating it any further. Unplug the unit from the wall outlet if it is not going to be used for several days or more. To disconnect the cord, pull it out by the plug. Never pull the cord itself. Allow adequate air circulation to prevent internal heat build-up. Do not place the unit on surfaces(rugs, blankets, etc. )or near materials(curtains, draperies)that may block the ventilation holes. Installation Do not install the unit in an extremely hot or humid place or in a place subject to excessive dust or mechanical vibration. [. . . ] Turn the control clockwise to increase and counterclockwise to decrease. 6) SHARPNESS Adjust the SHARPNESS control to obtain a clearer picture. 7) TINT (NTSC ONLY) Adjust the TINT control for the proper color phase or flesh tones. When turned counterclockwise, the skin tone becomes reddish. When turned clockwise, skin tone becomes greenish. 8) POWER LED LAMP Power lamp indicates the power is on. 9) POWER INLET Please use AC 100~240V, 50/60Hz. To prevent electrical shocks and fire hazards, do not use any other power source. 10) IMPEDANCE SWITCH Set the switch to the HIGH position if another monitor is connected to the VIDEO OUTPUT on the rear of the monitor. The last monitor should be set in the 75 position. Set the switch to the 75 position if the VIDEO OUTPUT is not used. 7 11) S-VHS/CAMERA SWITCH Set the switch to S-VHS(VIDEO) if you want to see the higher resolution S-VHS as the VIDEO. Set the switch to CAMERA if input signal is camera signal. 12) S-VHS JACK If you want to see the S-VHS(VIDEO), please connect directly to this jack. 13. 14) AUDIO INPUT & OUTPUT CONNECTOR Connect an RCA cable between these jacks and the audio jack of a camera or VCR. 15. 16) VIDEO INPUT & OUTPUT CONNECTORS These BNC connectors permit loop-through connection of a video signal in those installations where it is desirable to display the video signal on more than one monitor. 0Vp-p video signal applied to the VIDEO INPUT will also appear at the VIDEO OUTPUT. Use coaxial cables with BNC type plugs for these connections. 8 POSSIBLE CONNECTIONS Please read the installation/operation manual thoroughly before connecting equipment. Please turn off the power source before connecting the monitor and external equipment. One Monitor - External equipment (VIDEO) Camera Monitor to Monitor - External equipment (VIDEO) Camera Note : Maximum 3 monitors can be connected. To use S-VHS(VIDEO) input signal In this case, please set the switch to the S-VHS(VIDEO) position. 9 SAFETY INSTRUCTIONS IMPORTANT SAFEGUARDS All the safety and operating instructions should be read before the appliance is operated. Retain the instructions for future reference. 1) HEED WARNINGS All warnings on the appliance and in the operating instructions should be adhered to. 2) FOLLOW INSTRUCTIONS All operating instructions should be followed. 3) CLEANING Unplug this equipment from the wall outlet before cleaning. Use a water. dampened cloth for cleaning. 4) WATER AND MOISTURE Do not use this product near water-for example, near a bath tub, wash bowl, kitchen sink, swimming pool or laundry tub, or in a wet basement. 5) ACCESSORIES Do not place this product on an unstable cart, stand, tripod, bracket, or table. Do not drop. 6) VENTILATION Slots and openings in the cabinet are provided for ventilation. To ensure reliable operation of this product and to protect it from overheating, the openings must not be blocked or covered. This product should never be placed near or over a radiator or heat registor or in a built-in installation, such as a bookcase or rack, unless proper ventilation is provided. If you intend placing this Monitor into a cabinet or a wall alcove, please ensure there is at least a 100mm (10cm) gap to the sides, rear and top of the monitor. [. . . ] 15 ­12 Nishi Shinbashi, 2 ­ Chome, Minato ­ Ku, Tokyo 105-8430, Japan. Tel: 03 35022111 HITACHI EUROPE LTD, Whitebrook Park Lower Cookham Road Maidenhead Berkshire SL6 8YA UNITED KINGDOM Tel: 01628 643000 Fax: 01628 643400 Email: consumer -service@hitachi-eu. com HITACHI EUROPE S. A. 152 33 Chalandri Athens GREECE Tel: 1-6837200 Fax: 1-6835964 Email: service. hellas@hitachi-eu. com HITACHI EUROPE GmbH Munich Office Dornacher Strasse 3 D-85622 Feldkirchen bei München GERMANY Tel: +49-89-991 80-0 Fax: +49- 89-991 80-224 Hotline: +49-180-551 25 51 (12ct/min) Email: HSE- DUS. service@hitachi-eu. com HITACHI EUROPE S. A. [. . . ]