User manual HITACHI CPX960

[. . . ] · The manufacturer assumes no responsibility for any errors that may appear in this manual · The reproduction, transmission or use of this document or contents is not permitted without express written authority. TRADEMARK ACKNOWLEDGMENT : PS/2, VGA and XGA are registered trademarks of International Business Machines Corporation. Apple, Mac and ADB are registered trademarks of Apple Computer, Inc. VESA and SVGA are trademarks of the Video Electronics Standard Association. [. . . ] Image Menu Item Description Reduce size of top of image · When this function is activated, the image may not be displayed correctly with some input signals. Keystone Adjustment: KEYSTONE Reduce size of bottom of image Select Blank Screen Color: Select color with the BLANK MIRROR and buttons. · The image is cleared when the BLANK mode is set with BLANK ON, or when there is no signal, and the entire screen is displayed in the selected color. Operation Start/Stop: Press the or button. Select Mirror Status: Select mirror status with and Operation Start/Stop: Press the or button. Setup Initial Screen Display: Select TURN ON with the Clear Initial Screen Display: Select TURN OFF with the buttons. button. START UP · Note that if TURN OFF is selected the blank screen is displayed in blue when there is no signal. P. IN P. Operation Start/Stop: Press the or button. Display : Press the or ( · Valid only at RGB IN 1, RGB IN 2 or DIGITAL input. ) button. ENGLISH-14 OPERATIONS (continued) SETUP INPUT IMAGE OPT. 16 The following adjustments and settings are available when OPT. Select an item with the and buttons, and start operation. The function indicated (**) are effective on video input mode only, not on RGB input mode, except in the P. IN P. window on RGB input mode. VOLUME MENU COLOR LANGUAGE AUTO OFF SYNC ON G HDTV Table 7. Operation Start/Stop: Press the or button. SYNC ON G Valid: Select the TURN ON with the button. SYNC ON G Invalid: Select the TURN OFF with the button. · May not be displayed correctly with some input signals when the SYNC ON G is valid. In such cases, remove the signal connector so that no signal is received, set the SYNC ON G to invalid, and reconnect the signal. SYNC ON G ENGLISH-16 MAINTENANCE HIGH VOLTAGE HIGH TEMPERATURE HIGH PRESSURE Contact your dealer before replacing the lamp. For the optional lamp, see the item "Option Parts" of the Table 12. Before replacing the lamp, switch power OFF, remove the power cord from the power outlet, and wait approximately 45 minutes until the lamp has cooled. The lamp may explode if handled at high temperatures. WARNING · For disposal of used lamp, treat according to the instruction of community authorities. · Since the lamp is made of glass, do not apply shock to it and do not scratch it. This could also cause explosion of the lamp. · If it is probable that the lamp has exploded (explosive sound is heard), disconnect the power plug from the power outlet and ask your dealer to replace lamp. [. . . ] (2) The projector in creases the setting value on the above setting code. (3) The projector returns the response code `06H' to the computer. Decreasing the projector setting value (Decrement command) (1) The computer sends the decrement code Header + Command data (`05H'+`00H'+ type (2 bytes) +`00H' + `00H') to the projector. (2) The projector decreases the setting value on the above setting code. (3) The projector returns the response code `06H' to the computer. When a command sent by the projector cannot be understood by the computer When the command sent by the projector cannot be understood, the error command `15H' is returned by the computer. [. . . ]