User manual HITACHI CV-T190VDE

[. . . ] Motor is switched ON/OFF by changing the power switch 0 with finger. The tool is fitted with a brush at the back which can either be used in the "withdrawn" or "projected" position. These positions are operated by the pedal on the tool marked " " (Carpet) - and " " (Floor) =. [. . . ] Low suction pressure is recommended for cleaning curtains, blinds, delicate fabrics, etc. Brush head can be turned to adjust the angle La tête de la brosse peut être tournée pour régler l'angle Man kann den Kopf der Bürste drehen, um den Winkel zu verstellen Fig. Blockages may be cleared by separating the curved joint pipe 1 from the hose. To separate the joint pipe, depress the two claws 4 which are located in the holes 6 on both sides of joint pipe and pull apart. When needed, the hose collar @ can be removed from the hose end by turning it (left-handed screw). To reconnect, push hose back into joint pipe and twist until two claws 4 locate with holes 6. Likewise you can disconnect the hose joint on the other end of the hose. When the dust accumulation is excessive, remove the dust by the following procedure. Having disconnected the power cord and removed the hose, take off the upper case # by pressing the clamp $. The cleaner regains its strong suction power, even if some fluff still remains on the filter cloth. Be sure to replace the cloth filter after disposing of the dust. If the cleaner is used without replacing its filter, dust will be sucked directly into the mechanical parts and may damage the motor. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. Do not press or hit the clamp when carrying the cleaner. [. . . ] Do not allow children to play with cleaner. Do not leave cleaner connected to an electrical outlet and leave it unattended. Always disconnect cord from electrical outlet before servicing the cleaner. [. . . ]