User manual HITACHI CV710

[. . . ] · Never leave the appliance running unattended. · This vacuum cleaner is not intended for cleaning wet or damp flooring. Water entering the motor unit can cause permanent damage, putting the cleaner out of operation. [. . . ] Full-bag indicator Check the cleaning power by lifting the floor nozzle from the surface (with the power set to maximum) and the suction control on the hose closed. Should the indicator light, the dust bag must be replaced (figure 12). Replacing the dust bag After depressing the lid lock in the front of the lid (figure 13) , lift the lid to the open position (figure 14). Remove the holder carrying the dust bag (figure 15). Remove the dust bag from the dust bag holder by pulling the catch (figures 16a & 16b). Replace the dust bag in the dust bag holder. Its curved edge with the recess in the dust bag face should fit against the slot in the dust bag holder, so that the dust bag catch is engaged (figure 17). Following the above dust bag removal procedure in the reverse order, install the dust bag holder carrying the dust bag into the cleaner compartment and close the lid. Important: The safety catch (figure 20) does not allow the cleaner lid to be shut as long as there is no paper bag installed. Exchanging micro-filters 5 Usually after five paper bags have been filled, the micro-filters must be exchanged for new ones. To exchange the intake micro-filter, pull the grill holding the micro-filter upwards from the dust bag compartment (figure 21). Open the grill cartridge and exchange the micro-filter (figure 22). To exchange the exhaust micro-filters, press the lock in the cleaner grille bottom, lift the grille and remove it from the cleaner (figure 23). Remove the filter cartridge with the micro-filters (figure 24) and replace the filters with new ones (figure 25). WARNING: Failure to replace the micro-filters regularly can result in cleaner damage!Please ensure that replacement micro-filters are installed as detailed below: Pre-motor micro-filter: The pre-motor micro-filter must be installed so that its green side faces the cleaner compartment. [. . . ] 75 45 25 Specifications are subject to change for performance improvement without notice. This product conforms with directives 89/336/EEC and 73/23/EEC pertaining to electromagnetic compatibility and safety. 7 Hitachi, Ltd. Tokyo, Japan International Sales Division THE HITACHI ATAGO BUILDING, No. [. . . ]