User manual HITACHI D 6SH

[. . . ] The correct power tool will do the job better and safer at the rate for which it was designed. B) Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. C) Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. [. . . ] E) When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock 3) Personal safety a) Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Safety equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the switch or plugging in power tools that have the switch on invites accidents. D) Remove any adjusting key or wrench before turning the power tool on. Do not touch the bit during or immediately after operation. The bit becomes very hot during operation and could cause serious burns. When placing the drill on the floor, make sure that the drill has stopped completely. Before drilling into a wall, floor or ceiling, thoroughly confirm that no items such as electric cables or conduits are buried inside. When working in high position, take care of downword direction. Exposure to noise can cause hearing loss. Use auxiliary handles supplied with the tool. When mounting the drill bit, insert it fully into the drill chuck and completely tighten the drill chuck with the chuck wrench. If mounting is not done porperly, it is very dangerous as the drill bit may slip or loosen during operation. Do not wear gloves made of stuff liable to roll up such as cotton, wool, cloth or string, etc. Model Voltage (by areas)* Power input No-load speed Capacity: steel wood Weight (without cord) Spec. * Be sure to check the nameplate on product as it is subject to change by areas. 1 Standard accessories are subject to change without notice. Power source Ensure that the power source to be utilized conforms to the power requirements specified on the product nameplate. [. . . ] Inspecting the drill bit Since use of an abraded drill bit will cause motor malfunctioning and degraded efficiency, replace the drill bit with a new one or resharpening without delay when abrasion is noted. Should any of the screws be loosened, retighten them immediately, Failure to do so could result in serious hazard. Used D: Remarks CAUTION Repair, modification and inspection of Hitachi Power Tools must be carried out by an Authorized Service Center. This Parts List will be helpful if presented with the power tool to the Authorized Service Center when requesting repair or other maintenance. [. . . ]