User manual HITACHI DT3131E

[. . . ] till!iiCHl , . ` DT3131EUserManual 13. 3"Super TFT ColourLCD Monitor /"( ENERGY STAR As an international Energy Star Partner, Hitachi has determined that this product meets the International Energy Star Programme for energy efficiency. The International Energy Star Programme is a global programme that promotes energy saving through the use of computers and other office equipment. The programme backs the development and dissemination of products with functions that effectively reduce energy consumption. It is an open system in which business proprietors can participate voluntarily. [. . . ] Press the A button to save the new settings. When saving is completed "DONE" appears and the OSD window closes. 4 5 6 7 8 The adjustment settings are now saved and will be retained when the monitor is switched off. Note that you need to make the above adjustment separately for each video mode that you plan to use. 11 . s SYSTEM SET-UP An example system is shown below. Before making connection, make sure the power switch is turned off on each unit. The "O' side of the monitor switch must be pushed. (Refer to page 15. ) See your computer manual for details of the system unit power switch. To remove the monitor's rear cover press both sides of the top edge of the cover and push down, then pull the bottom edge towards you. To replace it, reverse these steps. , . Monitor 1 K """" Rear cover Ensure correct orientation, then push the plug onto the connector until it stops. Turn the screws clockwise to fasten the connector. Note: This computer system unit is an example only. 12 --. Do not place the product on an insecure surface. Be sure to remove the rear cover before connecting and disconnecting the power cord to and from the monitor. Insert the power plug until it stops with your hand fiiy holding the plug. . When connecting and disconnecting the power cord to and from the wall outlet, do it with your hand holding the plug. Insert the power plug fdy until it stops. Use a proper, safe power outle~ or contact failure could occur. Do not use any power cord other than the one provided. This monitor is ready for use immediately after setting up the computer system. If you need to adjust the monitor in any way please refer to the OSD (On-Screen Display) facility. Please refer to you system manual to set up the computer to a display mode supported by this monitor. For details check Video Modes on page 33. , ? . 13 OPERATION s CONTROLS AND CONNECTIONS -. w II '71 1 r Rear cover n c \\ D \ n Monitor cable o Power switch Power comector (bottom view) l-l `000" Buttons and Indicators 00 t POWER LED (green) SAVE LED (orange) BACK button SELECT button A button POWER SWITCH To turn the power on and off, push the "l" and "O" sides respectively. The "POWER' LED lights to indicate the power is on. (It takes 20 to 30 seconds for the display to be stable. [. . . ] . Note: Occasionally it may be possible to detect a few dots not working. This is normrd on TFT-LCD monitors and should not be reported as a fault. P . . 31 H VIDEO SIGNAL CONNECTIONS . 5 ( 00000 1 `~w~ 15-pin mini D-Sub connector (on the computer system unit) Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Signal Name R G B NC GND R-GND G-GND B-GND NC GND NC DDC-D* HSYNC VSYNC DDC-C** Signal Analogue red Analogue green Analogue blue Reserved Signal ground Return red Return green Return blue Reserved Signal ground Reserved DDC data Horizontal sync signal Vertical sync signal DDC clock output output output output In/Out output output output . . * Effective only on systems compliant with DDC 1 or DDC 2B ** Effective only on systems compliant with DDC 2B . 32 , . --. [. . . ]