User manual HITACHI DVPF3EUK

[. . . ] DVD/VCR Combo (DVD PLAYER with VIDEO CASSETTE RECORDER) INSTRUCTION MANUAL Recordable ReWritable PAL VIDEO Plus+ and PlusCode are registered trademark of Gemstar Development Corporation. The VIDEO Plus+ system is manufactured under licence from Gemstar Development Corporation. MODEL DVPF3EUK PROGRAM DVD OUTPUT VCR TIMER REC AV 3 VIDEO IN L (mono) AUDIO IN R Instruction manual To obtain the best performance and ensure years of troublefree use, please read this instruction manual completely. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. LASER SAFETY This unit employs a laser. [. . . ] When you press TIME SEARCH in step 2, it will increase the time by 15 minutes. In this case, Time Search can be set up to 9 hours 45 minutes (9:45). ¡This function will not operate in the Recording mode. ¡Operations must be followed up within 30 seconds, from step 2 to 3. Otherwise the Time Search mode will be cancelled. ¡To exit the Time Search mode, press the MENU in step 2. mode. ¡When you want to cancel the Quick-Find while in progress, press STOP (C). ¡When the end of a tape is reached during the Quick- Find, the tape will automatically rewind to the beginning. After rewinding finishes, the DVD/VCR will eject the tape. INDEX SEARCH ¡The index mark will be made automatically when REC is pressed. It will also be marked at the starting point of Timer recording and OTR. ¡The index mark is not recorded if the PAUSE/STEP (k) is pressed and released during recording recording. ¡The time gap between index marks on the tape should be greater than 1 minute for SP recording and 2 minutes for LP recording. ¡Use the remote control for this procedure . 1 Press INDEX SEARCH so that the Index Search menu appears. 2 Enter the number of recordings you wish to skip by pressing Arrow (o/p) within 30 seconds. INDEX 03 3 Press Arrow (s / B) to start index search. The DVD/VCR begins rewinding or fast forwarding to the beginning of desired programme. When the preset programme is reached, the DVD/VCR will start playback automatically. ¡If you want to go in the forward direction, press Arrow ( B). If you want to go in the reverse direction, press Arrow ({ ). ¡If you want to stop search function, press STOP ( C). ¡After index search, the VCR will play the tape automatically. ­ 22 ­ EN 2C15 RECORDING FUNCTION VCR It may be UNLAWFUL to record copyrighted material without the consent of the copyright owner. This DVD/VCR will operate with any cassette that bears the VHS mark. For best results, we recommend the use of high-quality tapes. Do not use poor quality or damaged tapes. ¡You can prevent accidental erasing of a recording by breaking off the erase prevention tab Tab on the back edge of the cassette. ¡If you decide to record on the tape again, cover the hole with plastic tape. OTR (One Touch Recording) VCR This feature allows you to set the recording length simply by pressing REC on the VCR. ¡REC on the remote control is not available for this procedure. 1 Press REC to begin OTR. [. . . ] DON'T listen to headphones at high volume, as such use can permanently damage your hearing. DON'T obstruct the ventilation of the equipment, for example with curtains or soft furnishings. Overheating will cause damage and shorten the life of the equipment. DON'T use makeshift stands and NEVER fix legs with wood screws -- to ensure complete safety always fix the manufacturer's approved stand or legs with the fixings provided according to the instructions. [. . . ]