User manual HITACHI FCJ 65V3

[. . . ] Do not use any adapter plugs with earthed (grounded) power tools. unmodified plugs and matching outlets will reduce risk of electric shock. B) Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. [. . . ] pRECAUTION Keep children and infirm persons away. When not in use, tools should be stored out of reach of children and infirm persons. * Be sure to check the nameplate on product as it is subject to change by areas. 1 Standard accessories are subject to change without notice. (2) Guide Optional accessories are subject to change without notice. Holding the blade with its cutting edge facing the front, insert the mounting portion of the blade into the plunger groove until it touches the bottom of the groove. Always ensure that the set screws are securely tightened. Always ensure that the plunger groove is clean and clear of sawdust to ensure proper blade mounting and set screw clamping. Storing the hexagonal bar wrench (1) Insert in a hole on the side of the main unit with holding the short side horizontally as shown in Fig. Cutting various lumber and pocket cutting Cutting mild steel plate, aluminum plate, and copper plate Cutting synthetic resins, such as phenol resin and vinyl chloride Cutting thin and soft construction materials Prior to use, adjust guide roller in accordance with the following procedures: (1) Loosen the holder set screw with the accessory hexagonal bar wrench. (2) Gently slide the guide roller until the roller groove lightly touches the back of the blade. NOTE On delivery from the factory, there is a gap of about 3mm between the roller and blade. (3) Firmly tighten the holder set screw. CAUTION The guide roller can be used only for Blades that have a straight line on the rear that is longer than 50mm. When cutting thick boards or performing continuous cutting operations, use the blade shown in the Fig. Power source Ensure that the power source to be utilized conforms to the power requirements specified on the product nameplate. Power switch Ensure that the power switch is in the OFF position. If the plug is connected to a receptacle while the power switch is in the ON position, the power tool will start operating immediately, which could cause a serious accident. Extension cord When the work area is removed from the power source, use an extension cord of sufficient thickness and rated capacity. The extension cord should be kept as short as practicable. Chip cover Use the chip cover to reduce flying of cut particles and to easily operate the saw. Slide the chip cover while lightly pressing its front section. [. . . ] The wire coloured brown must be connected to the terminal marked with the letter L or coloured red. Neither core must be connected to the earth terminal. NOTE This requirement is provided according to BRITISH STANDARD 2769: 1984 Therefore, the letter code and colour code may not be applicable to other markets except The United Kingdom. Inspecting the blade Continued use of a dull or damaged blade will result in reduced cutting efficiency and may cause overloading of the motor. [. . . ]