User manual HITACHI HDC-886E(ARGOS)

[. . . ] FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Select the desired setting with the / buttons, and press the SCN/SET button. To exit from the menu, press the MENU button. Size This sets the size of the image that will be captured. * [8M] 8M (3264 x 2448 pixels) * [6M] 6M (2816 x 2112 pixels) * [4M] 4M (2272 x 1704 pixels) * [2M] 2M (1600 x 1200 pixels) * [0. 3M] 0. 3M (640 x 480 pixels) Quality This sets the quality (compression) at which the image is captured. *[ ] Fine *[ ] Normal *[ ] Economy Color This sets the color of the image that will be captured. Balance This sets the white balance for a variety of lighting conditions and permits images to be captured that approach the conditions that are seen by the human eye. * [ h ] Fl1 * [ i ] Fl2 * [ c ] Daylight * [ d ] Cloudy *[ ] Manual Manual WB This manually sets the white balance and stores it. Use of this is convenient when the white balance does not offer a good match. Before selecting [Execute] and before taking your image, place a white paper in the scene and set the white balance manually. EN-18 ISO This sets the sensitivity for capturing images. When the sensitivity is raised (and the ISO figure is increased), photography will become possible even in dark locations, but the more pixelated (grainier) the image will appear. * Auto / 64 / 100 / 200 / 400 / 800 Metering This sets the metering method for calculating the exposure. * [ o ] Average: The entire area of the screen is measured, and the exposure is calculated. * [ q ] Spot: A very small portion of the center of the screen is measured, and the exposure is calculated. Sharpness This sets the sharpness of the image that will be captured. Saturation This sets the saturation of the image that will be captured. This sets the recording method at the time of capturing images. * [Blank] Single: Captures one image at a time. *[ ] Cont. : Permits continuous capture of up to 3 images. *[ ] AEB: Permits 3 consecutive images in the order of standard exposure, underexposure and overexposure compensation. *[ ] Burst: Permits continuous photography while pressing holding the shutter button. As long as you hold the shutter button pressed, images are captured until thememory capacity is exhausted. *[ ] Cont. flash: Permits continuous capture of up to 3 images with flash. *[ ] Pre-Shot: Lets you capture the background first, then have someone to capture you in front of it. [. . . ] Select this mode when you want to capture fast-moving subjects. g Night Portrait Select this mode when you want to capture people with an evening or night scene background. h Night Scene Select this mode when you want to capture dark scenes such as night views. c Candlelight Select this mode when you want to capture photos of candlelit scene, without spoiling the ambience. d Fireworks Select this mode when you want to capture fireworks clearly with optimal exposure. [. . . ]