User manual HITACHI HFC-VWE2

[. . . ] The meanings of these symbols are described below. WARNING This symbol indicates information that, if ignored, could possibly result in personal injury or even death due to incorrect handling. CAUTION This symbol indicates information that, if ignored, could possibly result in personal injury or physical damage due to incorrect handling. NOTICE This entry notices of fear of causing trouble. [. . . ] (3) Pressing the or ENTER button when selecting a STANDARD resolution will automatically adjust the horizontal and STANDARD vertical positions, clock phase and horizontal size. The INPUT_INFORMATION dialog will be displayed. (4) To set a custom resolution use the / buttons to select the CUSTOM and the RESOLUTION_CUSTOM box will be displayed. CUSTOM Set the horizontal (HORZ) and vertical (VERT) resolutions using the /// buttons. This function may not support all resolutions. (5) Move the cursor to OK on screen and press the or ENTER button. The message "ARE YOU SURE YOU WISH TO CHANGE RESOLUTION?" appears. The horizontal and vertical positions, clock phase and horizontal size will be automatically adjusted. The INPUT_INFORMATION dialog will be displayed. (6) To revert back to the previous resolution without saving changes, move the cursor to CANCEL on screen and press the or ENTER button. The screen will then return to the RESOLUTION menu displaying the previous resolution. Using / buttons switches the standby mode setting between NORMAL and SAVING. NORMAL ó SAVING · When SAVING is selected and the projector is in the standby state, the power consumption is lowered with some functional restrictions as below. - The RS-232C communication control is disabled except turning the projector on and changing the STANDBY MODE setting. - The STANDBY of the MONITOR OUT (below) is invalid, and no signal is output from the MONITOR OUT port. - The AUDIO OUT STANDBY of the AUDIO SOURCE (36) is invalid, and no signal is output from the AUDIO OUT ports (15). The combination of a picture shown on screen and output from the MONITOR OUT port can be arranged in the menu. The picture coming into the port selected in the (2) is output to the MONITOR OUT port while an image from the port chosen in the (1) is on screen. (1) Choose a picture input port using / buttons. COMPUTER IN1 ó COMPUTER IN2 STANDBY COMPONENT VIDEO ó S-VIDEO ó (Y, Cb/Pb, Cr/Pr) STANDBY MODE MONITOR OUT · Select STANDBY to specify the output from the MONITOR OUT port in the standby state. This selection is available only when NORMAL is selected for the STANDBY MODE (above). (2) Select one of the COMPUTER IN ports using / buttons. Choosing the COMPUTER IN1 allows the following choice. [. . . ] · Does the peripheral temperature exceed 35°C?If the same indication is displayed after the remedy, please set FAN SPEED of SERVICE item in OPTION menu to HIGH (45). It is time to clean the air filter. Lighting In Green Simultaneous blinking in Red Please immediately turn the power off, and clean or change the air filter referring to the section "Cleaning and replacing the air filter". After cleaning or changing the air filter, please be sure to reset the filter timer. After the remedy, reset the power to ON. Lighting In Green Alternative blinking in Red There is a possibility that the interior portion has become overcooled. Please use the unit within the usage temperature parameters (5°C to 35°C). [. . . ]