User manual HITACHI TRAVELSTAR VP QUICK INSTALLATION GUIDE

[. . . ] The following procedure uses the Ontrack Disk Manager software. Information on obtaining a copy of Ontrack's Disk Manager can be found on the Web at www. ibm. com/harddrive. In a one drive system, configure your new drive as Master (Device 0) with no jumpers installed. [. . . ] Save the drive packaging material including the ESD bag in the event that the drive must be returned. Place the drive in an anti-static bag before placing it in the shipping container. The warranty will be void if the drive is not returned in IBM approved packaging. No Jumper (Master) Jumper Pos-1 (Slave) Jumper Pos-3 (Cable Select) Never Attach A Jumper Here! Never Attach A Jumper Here! Note: Pin-20 is left blank for secure connector insertion. Note: When 49-pin is grounded, no spin-up at POR; when open, normal spin-up at POR Page 1 IBM Hard Disk Drive Technical Support Center version 3. 0 IBM storage products Attaching the drive 1. Turn off the computer, unplug the power cord, and open the cover. Match pin 1 of the 44 pin cable to pin 1 of the drive interface connector. Pin 1 is usually denoted by a stripe along the edge of the cable. If your computer has a plug-in IDE card with a drive installation procedure, follow the manufacturer's instructions. Plug in the power cord and power on your computer. Your computer may detect a configuration change and prompt you to proceed to the Setup screen. If your computer does not prompt you to reconfigure, enter your computer's Setup, typically by key selection or keyboard combinations during power-on or during a reboot. Refer to your computer's documentation for the proper key sequence. If the computer fails to boot up, power off, remove the new hard drive and return your system to its original configuration. Reboot and enter your computer's Setup. Follow the directions in step 4, then reattach the new hard drive. Select "Auto Detect" if your computer Setup supports this feature. [. . . ] Under "Select an Installation Option", select (E)asy Disk Installation. Select a drive for installation; Disk Manager will partition and format the drive. A status dialog will indicate a successful installation. [. . . ]