User manual HITACHI ULTRASTAR 18LZX QUICK INSTALLATION GUIDE

[. . . ] Quick installation guide Ultrastar 36ZX & 18LZX Multimode SE/LVD Models: DMVS-09 DMVS-18 DMVS-36 4. Discharge the static electricity from the package and from your body. With one hand touch an unpainted metal surface on your computer chassis, then touch the ESD bag with the other hand for at least 2 seconds. [. . . ] Backup all data before proceeding with the installation. Open the case as directed by your computer system manual. Page 1 IBM Hard Disk Drive Technical Support Center address 7 version 2. 0 34L3743QI10 The Auxiliary Option Block connector depicted below is used in external cases with standardized external switch connectors. Partitioning and formatting (using DOS 5. 0 or later) Caution: Partitioning and formatting will erase all data. Auxiliary Connector :::::: Enable Active Termination SCSI Address ID2 +5V 11 9 ID3 7 ID0 ID1 531 12 10 8 Write Protect Ground 642 Unused Slave Sync 1. Insert the OS setup diskette into the floppy drive. At the DOS prompt type FDISK, press [ENTER], and follow the instructions on the screen. To format the primary system drive, type FORMAT C:/S at the DOS command prompt and press [ENTER]. The /S parameter makes C: the operating system startup drive. To format a second drive (not C:), type FORMAT X: (where X is the drive letter assigned by FDISK) at the DOS prompt and press [ENTER]. Remove the diskette and restart your computer. Install the operatings system. External Activity LED Auto Spin Start 8. If the drive is the only device on the SCSI cable, attach it to the end of the cable furthest from the controller. (The using system is responsible for making sure that all required signals are terminated at both ends of the cable. ) 10. Select the other option jumpers as required by your computer. External Activity LED Reserved ® © International Business Machines Corporation 1999 www. ibm. com/harddrive IBM Hard Disk Drive Technical Support Center Dept. WCN 3605 Highway 52 North Rochester, MN 55901 Telephone: 888. IBM. 5214 or 507. 286. 5825 Fax: 507. 253. DRIVE E-mail: drive@us. ibm. com Singapore Technical Support Center Telephone: 1800. 418. 9595 or 65. 6. 418. 9595 E-mail: drive@sg. ibm. com IBM Systems Storage Division 5600 Cottle Road San Jose, CA 95193 www. ibm. com/storage Printed in the United States of America 6-99 All Rights Reserved IBM is the registered trademark of International Business Machines Corporation. Write Protect Auto Start Delay Force Single Ended Mode Ground Auto Start Enable /Disable SCSI Address Blank Disable Sync Negotiations Disable SCSI Parity Disable Unit Attention Disable Wide Negotiations 321 | | | 0 | 1 357 11 13 15 17 19 21 23 25 27 29 31 2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 Ground Reserved +5V Ground 11. Mount the drive securely in any axes, using the appropriate brackets or rails. [. . . ] This product data does not constitute a warranty. Questions regarding IBM's warranty terms or methodology used to derive this data should be referred to the IBM Hard Disk Drive Technical Support Center. Date: 21 October, 1999 Page 2 IBM Hard Disk Drive Technical Support Center version 2. 0 34L3743QI10 [. . . ]