User manual HITACHI ULTRASTAR 36Z15 QUICK INSTALLATION GUIDE
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual HITACHI ULTRASTAR 36Z15. We hope that this HITACHI ULTRASTAR 36Z15 user guide will be useful to you.
Lastmanuals help download the user guide HITACHI ULTRASTAR 36Z15.
You may also download the following manuals related to this product:
HITACHI ULTRASTAR 36Z15 DATASHEET (563 ko)
Manual abstract: user guide HITACHI ULTRASTAR 36Z15QUICK INSTALLATION GUIDE
Detailed instructions for use are in the User's Guide.
[. . . ] Handle the drive carefully by the edges. Do not touch the exposed printed circuit board or any electronic components. Covering the breather hole may result in loss of data. [. . . ] If for some reason the drive cannot detect an SE mode bus, place a jumper on pins 5 & 6 of jumper block J-4 to force SE mode. On 68-pin drives termination power must be provided. In most cases it is provided by the host adapter. If it is not, install a jumper on pins 3 & 4 of jumper block J-4 to enable termination power. (The 80-pin drive does not provide termination power. ) CAUTION: Partitioning and formatting will destroy any previous data. When partitioning and formatting a drive in a system with more than one drive be sure that you select the correct hard drive. With the OS setup diskette inserted in the floppy drive, turn on the computer. At the DOS prompt type FDISK, press ENTER, and follow the instructions on the screen. To format the primary system drive, type FORMAT C:/S at the DOS command prompt and press ENTER. The /S parameter makes C: the startup drive of the operating system. To format a second drive (not C:), type FORMAT X: (where X is the drive letter assigned by FDISK) at the DOS prompt and press ENTER. Remove the diskette and restart your computer. The partitioning and formatting is complete. Install the operating system.
Y
9. For a 68-pin drive attach the power cable and ensure that one end of the SCSI cable is connected to the host adapter. Attach a terminator to the end of the SCSI cable furthest from the host adapter. If the drive is the only device on the SCSI cable, attach it to the cable connector closest to the terminator. Additional drives may be attached to any unused connector. [. . . ] Questions regarding IBM's warranty terms or methodology used to derive this data should be referred to the IBM Technology Group Support Center. Date: 16 April 2001
Y Y Y
If the system boots up, turn off your computer and replace the cover. If your system does not boot up, turn off your computer and check all connections and settings. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE HITACHI ULTRASTAR 36Z15
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual HITACHI ULTRASTAR 36Z15 will begin.
HITACHI ULTRASTAR 36Z15 DATASHEET (563 ko)
