User manual HITACHI ULTRASTAR 9ES QUICK INSTALLATION GUIDE

[. . . ] IBM storage products Quick installation guide Ultrastar 9ES SCSI Models: DDRS-34560 DDRS-39130 Handling precautions 1. Covering the breather hole may result in loss of data. 2. Do not apply any force to the drive during handling or installation. Setting the address 1. [. . . ] (This drains static electricity from the package and from your body. ) 7. Handle the drive carefully by the edges. Do not touch any exposed printed circuit board. Save the drive packaging material including the ESD bag in the event that the drive must be returned. Place the drive in an anti-static bag before placing it in the shipping container. The warranty will be void if the drive is not returned in IBM approved packaging. Ground 23 (1) 24 21 (2) 22 19 (3) 20 17 (4) 18 15 (5) 16 13 (6) 14 11 (7) 12 9 (8) 10 7 (9) 8 5 (10) 6 3 (11) 4 Bit 3 Bit 2 Bit 1 Bit 0 Enable Auto Spin Up Enable SCSI Terminator (50, 68 pin) Disable Unit Attention Enable TI-SDTR (50-pin) Enable TI-SDTR/WDTR (68, 80 pin) Enable Auto Start Delay Delay Start 6/12 Disable SCSI Parity Check LED Cathod LED Anode 1 (12) 2 Power Connector Logic Card Back side of drive Installation procedure It is advisable to backup all data before proceeding with the installation. This procedure may require use of a bootable System Diskette containing FDISK. COM and FORMAT. COM. IBM Hard Disk Drive Technical Support Center SCSI I/F Connector JP1 Option blcok JP12 Page 1 version 3. 0 IBM storage products Note: In the table below, "off" means a jumper is not in place and "on" means a jumper is in place. Bit 3 off off off off off off off off on on on on on on on on Bit 2 off off off off on on on on off off off off on on on on Bit 1 off off on on off off on on off off on on off off on on Bit 0 off on off on off on off on off on off on off on off on Address 0 1 2 3 4 5 6* 7 8 9 10 11 12 13 14 15 ® © International Business Machines Corporation 1999 www. ibm. com/harddrive IBM Hard Disk Drive Technical Support Center Dept. D8M 3605 Highway 52 North Rochester, MN 55901 Telephone: 888. IBM. 5214 or 507. 253. 4110 Fax: 507. 253. DRIVE E-mail: drive@us. ibm. com Singapore Technical Support Center Telephone: 65. 840. 9292 E-mail: drive@sg. ibm. com IBM Systems Storage Division 5600 Cottle Road San Jose, CA 95193 www. ibm. com/storage Asia-Pacific Headquarters: 65. 320. 1234 European Headquarters: 44. 01. 705. 561. 871 Japan Sales Branch Office: 81. 46645. 1039 Printed in the United States of America 01-99 All Rights Reserved IBM is the registered trademark of International Business Machines Corporation. Other company, product, and service names may be trademarks or service marks of others. Produced by the IBM Hard Disk Drive Technical Support Center. OEM Hard Disk Drive Specifications for DDRS-39130 / DDRS-34560 (Revision 2. 0) Product Description data represents IBM's design objectives and is provided for comparative purposes; actual results may vary based on a variety of factors. This product data does not constitute a warranty. Questions regarding IBM's warranty terms or methodology used to derive this data should be referred to the IBM Hard Disk Drive Technical Support Center. Date: 6 January 1999 * Shipping Default Attaching the drive 1. Turn off the computer, unplug the power cord, and open the case. The DDRS drive requires Active Termination on both ends of the SCSI cable (the SCSI controller normally provides internal termination for one end of the cable). [. . . ] Follow the Operating System instructions to format and partition your drive. If your system will not boot up after complete installation, recheck all settings. If the system still fails to boot up, remove the new drive to return the system to its original configuration and call the IBM Hard Disk Drive Technical Support Center. Page 2 IBM Hard Disk Drive Technical Support Center version 3. 0 [. . . ]