User manual HITACHI ULTRASTAR 9LZX QUICK INSTALLATION GUIDE

[. . . ] Each drive on the SCSI bus must have a unique address. Sixty eight and eighty pin (Wide SCSI) devices have 16 possible addresses. SCSI address bits 3, 2, 1, and 0 of the 32 pin Option Jumper Block are used to select the SCSI device ID. External Activity LED Write Protect Ground Auto Start Blank SCSI ID Auto Start Delay 2. [. . . ] Place the drive in an anti-static bag before placing it in the shipping container. The warranty will be void if the drive is not returned in IBM approved packaging. 3 2 1 5 0 7 13 11 13 15 17 19 21 23 25 27 29 31 24 6 8 10 12 14 16 18 20 22 24 26 28 30 32 Ground Reserved +5V Ground Ground Termination Power Enable Note: In the table below, "off" means a jumper is not in place and "on" means a jumper is in place. Bit 3 off off off off off off off off on on on on on on on on Bit 2 off off off off on on on on off off off off on on on on Bit 1 off off on on off off on on off off on on off off on on Bit 0 off on off on off on off on off on off on off on off on Address 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Page 1 IBM Hard Disk Drive Technical Support Center version 4. 0 IBM storage products 3. To format a second drive (not C:), type FORMAT X: (where X is the drive letter assigned by FDISK) at the DOS prompt and press [ENTER]. Remove the diskette and restart your computer. If your system will not boot up after complete installation, recheck all settings. If the system still fails to boot up, remove the new drive to return the system to its original configuration and call the IBM Hard Disk Drive Technical Support Center. Auxiliary Connector :::::: SCSI Address ID2 +5V 11 9 ID3 7 ID0 ID1 531 12 10 8 Write Protect Ground 642 Unused Reserved External Activity LED Auto Spin Start Attaching the drive 1. Turn off the computer, unplug the power cord, and open the case. If the DRVS drive is the only device on the SCSI cable, attach it to the end of the cable furthest from the controller. (Note that the using system is responsible for making sure that all required signals are terminated at both ends of the cable. ) 3. Select the other option jumpers as required by your computer. Mount the drive securely, using the appropriate brackets or rails, in any axes, using four 6-32 UNC metric screws in the bottom or side mounting holes. The maximum screw insertion depth for mounting is 4. 0mm. Plug in the power cord, insert the System Diskette and power on your computer. Your computer may detect a configuration change and prompt you to proceed to the Setup screen. If your computer does not prompt you to enter reconfiguration, refer to your computer's documentation for the proper key sequence. Follow the Setup menu to configure your computer with your new SCSI drive. [. . . ] Produced by the IBM Hard Disk Drive Technical Support Center. Hardware/Functional Specification, version 2. 20 Parallel SCSI Disk Drive Logical Interface Specification, release 1. 1 Product Description data represents IBM's design objectives and is provided for comparative purposes; actual results may vary based on a variety of factors. This product data does not constitute a warranty. [. . . ]