User manual HITACHI UT32X802

[. . . ] TM Director's Series 32" HDTV Monitor ® 1. 5" UltraThin Liquid Crystal Display Black Sapphire Crystal Frame 1366 x 768p with High Efficiency EEFL Backlight (1) HDMITM (V. 1. 3 with CEC) Input; (1) RGB D-sub15 Input with Audio Operating Guide UT32X802 Model Name READ THE ENCLOSED INSTRUCTIONS CAREFULLY. KEEP THIS OPERATING GUIDE FOR FUTURE REFERENCE. Record the serial number of your monitor for future reference. SERIAL NO. This serial number is located on the back and right side of the monitor. CONTENTS IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . 02 INTRODUCTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 04 About This Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 04 Trademark Credits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Select "RGB" to display the image from PC. See 40 and 41 for details of "RGB input" menu. Input Signal Screen Display The input signal status can be displayed on the screen by pressing the button on the remote control. The display will go out in approximately 6 seconds. Input mode HDMI mode HDMI DVI 720p * Signal mode * HDMI-DVI connection only RGB mode Input mode Input horizontal frequency Input vertical frequency INFO button RGB H : 48. 4kHz V : 60. 0 Hz Composite mode Composite 24 ENGLISH Input Switching to HDMI and RGB SETUP OPERATION How to Use the Remote to Control your External Devices OPERATING THE PRECODED FUNCTIONS FOR YOUR EXTERNAL DEVICES. The new remote control is designed to operate different types of VCRs, cable boxes, set-top-boxes, satellite receivers, DVD players, and other audio/video equipment. You must first program the remote to match the remote system of your external equipment (refer to pages 31 ~ 32 for precodes). EXTERNAL DEVICE CONTROL SETUP PROCEDURE 1. Select the desired device mode DVD, PVR/VCR, SAT/CBL or AVR by pressing the corresponding device button. Hold down the device button (DVD, PVR/VCR, SAT/CBL or AVR) on the remote and enter the four digit preset code that matches your device as shown on pages 31 ~ 32 . If done correctly, the device LED indicator will blink 3 times to confirm proper setup. The remote will now control the desired device. Power button Device buttons Numeric buttons 4. 6. SETUP EXAMPLE (Hitachi Cable Box with precode 0003) 1. Select Cable mode by using your SAT/CBL button to position the LED indicator on SAT/CBL. Hold down the SAT/CBL button on the remote and press the numbers 0, 0, 0 and 3. The indicator light will flash 3 times if the code was accepted. Aim the remote at the cable box and press the POWER button. The remote will turn off your cable box when the correct four digit preset code is entered. When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off, try a different four digit preset code. The remote will now control your Cable box. Remote Control Backlight Feature When you press any remote control button, the buttons will light up. The illumination will light a few seconds during this time. The buttons will appear to light if the room is dark. 7. Repeat the same procedure for your set-top-box or satellite receiver (select SAT/CBL), your DVD (select DVD), your VCR/PVR(select VCR/PVR), or your AVR (select AVR). NOTE Disabling Remote Control Backlight Feature 1. [. . . ] All right, title and interest in and to the Software and any intellectual property associated therewith, including any accompanying printed materials, shall belong to HITACHI and its licensors and suppliers. Except as expressly provided herein, neither HITACHI nor any of its licensors or suppliers grants to you under this Agreement any express or implied right in or to any patents, copyrights, trademarks, trade secrets or other intellectual property. All right, title and interest in and to the intellectual property rights associated with any content that is accessible through use of the Software shall belong to the applicable content owners and may be protected by copyright or other intellectual property laws and treaties. This Agreement grants you no rights to use such content. [. . . ]