User manual HITACHI VTF650EUKN

[. . . ] HITACHI HOME ELECTRONICS (AMERICA), INC. 3890 Steve Reynolds Blvd. , Claire, Quebec Norcross, GA 30093 CANADA Tel. 404-279-5600 HITACHI SALES CORPORATION OF HAWAII, INC. 514-697-9150 3219 Koapaka Street Honolulu, HI 96819 Tel. [. . . ] Press PLAY and REW, then hold REW for backward search at a higher speed. Press PLAY and F. FWD, then hold F. FWD for forward search at a higher speed. Release REW or F. FWD to return to normal playback Still Playback (Pause) Press PAUSE on the remote control or PLAY/STILL on the VCR to still the tape during play. You may see some minor noise or interference on the screen. After 1 minute in PAUSE mode, the VCR automatically switches to STOP mode to protect the tape. If noise bars appear on the TV screen during PAUSE mode, first set the VCR to SLOW mode by using the SHUTTLE dial and then press the CHANNEL up or down button to minimize the noise bars. If the screen jitters during PAUSE, press the CHANNEL up or down button to minimize it. To resume play, press PLAY or PAUSE again. 28 Basic Operations (Playback) If you press the DISPLAY button when viewing a videocassette, the display, as shown, appears for several seconds so you can see the functions of the number buttons on the remote control. 4: SLOW 6: F ADV The above functions always work when you are viewing a videocassette even if the display, as shown, is not displayed. Frame Advance While in PAUSE mode during playback, press 6 button to view the video one frame at a time. Skip Playback While playing back your tape you can skip forward by pressing the 6 button. Press CLEAR repeatedly to switch the type of the tape used. The correct remaining time will appear. AUTO: T-120 or shorter tape T-160: T-140 or T-160 tape T-180: T-180 tape T-210: T-210 tape The tape remaining time is not displayed correctly for a tape without any recordings or tapes other than T-30 / 60 / 90 / 120 / 140 / 160 / 180 / 210. The remaining time may not be displayed correctly during fast forwarding or rewinding. To Find Specific Sections on a Tape Searching with the Time Counter If there is one part of the video that you know you are going to want to return to, you can set the time counter to memorize that spot. Press DISPLAY several times to display the counter on the VCR. At the point that you want to go back to, press CLEAR. Press STOP when you are done recording or playing back the tape. Now when you rewind the tape, it will automatically stop at the spot where you cleared the counter. (Notice it moves just past the marker and then back to it. ) Press PLAY to watch the tape from that preselected spot. Press DISPLAY to take the counter display off. The spot is still in memory until you set a new one or until the tape is ejected. [. . . ] I - Hitachi reserves the right to cancel the Protection Plan in case of abuse by the owner, in such case, Hitachi will reimburse the owner the portion of the plan cost, based on the period used. J - This plan does not constitute an insurance policy. It is the owner's responsibility to insure for loss of the product and for any damages which might occur and for loss or damages to any other object and for personal or property liability caused directly or indirectly by the product. 61 HITACHI CANADA WARRANTY CARD (Back) HITACHI CANADA WARRANTY CARD (Back) Hitachi VIDEO PRODUCTS are guaranteed to be free from defects in workmanship and material. If any failure resulting from either workmanship or material defect should occur under normal and proper usage within the period stated hereunder from the original provable date of purchase, such failure should be repaired at no cost to the buyer, provided the defective product is brought to a HITACHI AUTHORIZED SERVICE CENTER in Canada. [. . . ]