User manual HOLMES HACP9TG

[. . . ] Be sure to pull by the plug and not the cord. DO NOT operate without fan grills properly in place. HACP 9 fan 9/00 8) DO NOT operate any appliance with a damaged cord or plug, if motor fan fails to rotate, after the appliance malfunctions, or if it has been dropped or damaged in any manner. Return appliance to manufacturer for examination, electrical or mechanical adjustment, or repair. [. . . ] · Do not allow water to drip on or into the fan motor housing. · Do not use any of the following as a cleaner: gasoline, thinner, benzine Step 1: To access the fan blade, remove the front grill by pressing the tabs on the grill ring away from the fan. Step 2: Clean the fan blade, both front and rear grills with a soft cloth moistened with a mild soap solution. NOTE: FAN BLADE SHOULD NOT BE REMOVED Step 3: Replace the front grill by snapping back into rear grill. Fan Head and Clip Cleaning Using a soft, moist cloth, with or without a mild soap solution, carefully clean the fan head. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water. WALL MOUNTING INSTRUCTIONS NOTE: On the underside of the fan's clip there are "KEY SLOTS" (2). Select a suitable spot on a wall (away from curtains, draperies, or heat sources) where you want to mount the fan. 10 pan head wood screw (1 1/4" length) and thread into a 2x4 wood stud behind the dry wall. Please refer to the warning below if you are unable to locate a wood stud in the wall. When threading the screw into the wall, leave approximately 1/4" clearance between the screw and wall. This will allow the clip's "KEY SLOTS" to fit easily and securely over the screws. If necessary, the screw may be tightened further to ensure the fan is firmly attached to the wall. WARNING: WHEN MOUNTING THE FAN TO PLASTER, DRYWALL OR SHEETROCK, YOU MUST USE A MOLLY BOLT, OR SIMILAR FASTENER. DOING SO WILL PREVENT THE FAN FROM BECOMING DISLODGED WHILE IN OPERATION. FAN STORAGE In the off-season: · IMPORTANT: Keep your fan in a safe dry location, where the fan is not likely to fall or be crushed. · Your fan should be stored fully assembled. · Remember to protect the fan head from dust or moisture. ADJUSTMENT INSTRUCTIONS Vertical Angle Adjustment Step 1: Step 2: To change the tilting angle of the fan head, simply loosen the tilt adjustment knob. Move the fan head to the desired angle, then firmly tighten the knob to lock the fan head in place. Horizontal Angle Adjustment Turn the motor housing to the desired direction. WARNING: MAKE SURE TO SUPPORT THE FAN HEAD ASSEMBLY WHEN LOOSENING THE ADJUSTABLE HEIGHT NUT, AS THE WEIGHT OF THE FAN HEAD MAY CAUSE THE EXTENSION POLE TO COLLAPSE. SERVICE INSTRUCTIONS 1. Do NOT attempt to repair or adjust any electrical or mechanical functions on this unit. If you have any questions regarding this unit's operation or believe any repair is necessary, please write to our Consumer Service Department. If you need to exchange the unit, please return it in its original carton, with a sales receipt, to the store you purchased it. If you are returning the unit more than 30 days after the date of purchase, please see the enclosed warranty. [. . . ] Carefully pack the item in its original carton or other suitable box to avoid damage in shipping. Before packing your unit for return; be sure to enclose: a) your name, full address with zip code and telephone number, b) a dated sales receipt or PROOF OF PURCHASE, c) your $5. 00 check for return packaging, and d) The model number of the unit and the problem you are having. (Enclose in an envelope and tape directly to the unit before the box is sealed. ) 3. Holmes recommends you insure the package (as damage in shipment is not covered by your warranty). [. . . ]