User manual HOLMES HASF1320

[. . . ] 8) DO NOT operate any appliance with a damaged cord or plug, if motor fan fails to rotate, after the appliance malfunctions, or if it has been dropped or damaged in any manner. Return appliance to manufacturer for examination, electrical or mechanical adjustment, or repair. 9) DO NOT operate in the presence of explosive and/or flammable fumes. 10) Use appliance only for intended household use as described in this manual. [. . . ] Make sure the shaft protrudes from the front of the blade. Step 4: Secure the fan blade onto the motor shaft by turning the blade cap in a counter-clockwise direction until it is firmly in place. Step 5: Center the front grill by aligning the Holmes logo so it is horizontal and parallel to the floor. Then secure the front and rear grills completely together by placing the front grill onto the back grill making sure the Holmes logo is straight. Then close and lock the clips into place around both grills. Final Assembly Step 1: Place and slide the upper pole and fan head assembly onto one of the extension poles. Then, simply insert the fan post screw into the hole and tighten until a secure fit is obtained. OPERATING INSTRUCTIONS Step 1: Set the fan base on a dry, level surface. Step 2: Please make sure the On/Speed knob is in the "O" Off position. Plug the cord into any standard 120-volt A/C outlet. Step 3: The SPEED is adjusted by moving the knob left or right to the desired setting. Step 4: The OSCILLATION control knob is located on the top of the fan motor housing. To start oscillation, push control knob down. To stop oscillation, pull control knob up. ADJUSTMENT INSTRUCTIONS Tilt Adjustment To change the tilting angle of the fan head, move the fan head to the desired angle. Height Adjustment (See instructions for base/pole assembly) This fan is equipped with two extension poles, which allow you to adjust the height of the fan for two height settings. CLEANING/MAINTENANCE Follow these instructions to correctly and safely care for your Holmes stand fan. Please remember: · Always unplug the fan before cleaning or disassembling. · Do not allow water to drip on or into the fan motor housing. · Do not use any of the following as a cleaner: gasoline, thinner, benzine (See instructions for fan head assembly) Step 1: To access the fan blade, remove the front grill and the fan blade nut. Step 2: Clean the fan blade, both front and rear grills with a soft cloth moistened with a mild soap solution. Step 3: Replace blade, tighten the fan blade nut, and securely fasten the front grill. Fan Head, Base, and Pole Cleaning Using a soft, moist cloth, with or without a mild soap solution, carefully clean the fan base, pole, and head. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water. FAN STORAGE Your fan can be stored in the off-season either partially disassembled or assembled. [. . . ] To the extent that any provision of this warranty is inconsistent with any applicable law, such provision shall be deemed voided or amended, as necessary, to comply with such law. SAVE THIS WARRANTY INFORMATION SERVICE INSTRUCTIONS 1. Do NOT attempt to repair or adjust any electrical or mechanical functions on this unit. If you have any questions regarding this unit's operation or believe any repair is necessary, please write to our consumer service department. If you need to exchange the unit, please return it in its original carton, with a sales receipt, to the store you purchased it. [. . . ]