User manual HOLMES HASF1521GRC

[. . . ] 8) DO NOT operate any appliance with a damaged cord or plug, if motor fan fails to rotate, after the appliance malfunctions, or if it has been dropped or damaged in any manner. Return appliance to manufacturer for examination, electrical or mechanical adjustment, or repair. 9) DO NOT operate in the presence of explosive and/or flammable fumes. 10) Use appliance only for intended household use as described in this manual. [. . . ] Step 4: Secure the fan blade onto the motor shaft by turning the blade cap counter-clockwise (make sure the blade is firmly in position. ) Step 5: Snap the logo plate on to the front grill, making sure the clips on the logo plate, fit into the openings on the front grill. NOTE: SHOULD ANY GRILL CLIPS BREAK; THERE ARE EXTRAS IN THE BOX. Step 6: Center the front grill, aligning the Holmes logo so it is horizontal and parallel to the floor, place onto the rear grill, and snap in place by pushing front grill onto clips while holding clips. Final Assembly Step 1: Place the hollow end of the remote control housing (female end) on to the upper extension pole until it will not go down any further. Step 2: Tighten the locking nut on the back of the remote control housing by turning it clockwise until it doesn't turn any further. OPERATING INSTRUCTIONS STEP 1: Set fan on a dry, level surface. STEP 2: Plug cord into any standard 120V AC outlet. STEP 3: The speed is adjustable by pushing either the SPD button on the remote control, or the ON/SPEED button on the touch-key pad. Push this button first for LOW, again for MEDIUM, and a third time for HIGH. Push a fourth time to repeat the sequence. To turn the fan OFF, push the OFF button on the remote control, or on the touch-key pad. STEP 4: To oscillate the fan head, push the button marked OSC on the remote, or OSCILLATE on the touch-key pad. STEP5: For a natural breeze movement, push the button marked BRZ/SLP, or BREEZE on the touch-key pad. This will vary the fan speeds faster and slower. By pressing the BRZ/SLP button a second time, or the SLEEP button on the touch-key pad, you activate the SLEEP setting. This function slows the fan speed down, and when used in conjunction with the timer settings, will ultimately turn the fan off. NOTE: Both the BREEZE and SLEEP functions can be used with or without OSCILLATION, and start off of any initial fan speed. STEP 6: This fan is equipped with a 4-setting stop timer. (8 hrs, 4 hrs, 2 hrs, and 1 hr) To activate the timer, push the TMR button on the remote control, or the TIMER button on the touch-key pad. One push will set the 1 hr, the next push sets the 2 hr, the third push activates the 4 hr, and the fourth push sets the 8 hr. Push again to begin repeating this sequence. NOTE: The timer can be used in conjunction with several other functions. TIMER causes the fan to gradually slow down over 4 hours and eventually turn off. ILLUSTRATIONS (fig 1) CUTAWAY/ GROOVES POLE THREADED JOINT (male end) HOLLOW END OF BASE COVER ON TOP BASE COVER WEIGHTED INSERT BASE NUT Remote Control Handheld Unit: Your remote control requires 2 AAA batteries for operation. [. . . ] Carefully pack the item in its original carton or other suitable box to avoid damage in shipping. Before packing your unit for return; be sure to enclose: a) your name, full address with zip code and telephone number, b) a dated sales receipt or PROOF OF PURCHASE, c) your $12. 50 check for return packaging, and d) The model number of the unit and the problem you are having. (Enclose in an envelope and tape directly to the unit before the box is sealed. ) 3. Holmes recommends you insure the package (as damage in shipment is not covered by your warranty). [. . . ]