User manual HOLMES HASF1710

[. . . ] · To disconnect, grip plug and pull from wall outlet. · Always use on a dry, level surface. · Do not operate without fan grills properly in place. · This product is intended for household use ONLY and not for commercial or industrial applications. [. . . ] To the extent that any provision of this warranty is inconsistent with any applicable law, such provision shall be deemed voided or amended, as necessary, to comply with such law. PLEASE USE THIS FORM TO ORDER-BY-MAIL. A photocopy of this form will not be accepted ITEM # MDB DESCRIPTION FanBonnet for HASF-1710 QUANTITY PRICE $8. 99ea Shipping and Handling Applicable Provincal Taxes GST TOTAL $2. 00 SUB TOTAL Method of Payment: Cheque Money Order PHONE# SHIP TO: (PLEASE PRINT) STREET CITY PROVINCE POSTAL CODE To order, please send your cheque or money order, and this completed form to: HOLMES, P. O. BOX 279, PORT CREDIT, ONTARIO L5G 4L8 HASF-1710-CSA-ENG-99-MN-01 Printed in China Page 4 Assembly Instructions: Base/Pole Assembly: You will need the base cover, weighted insert, pole, pole ring, and Lshaped locking lever. STEP 1: Slide the bottom end of the pole through the pole ring. STEP 2: Turn the base cover upside down and place the weighted insert into the base cover. STEP 3: Insert the threaded end of the locking lever into the hole of the weighted insert and through the base cover. STEP 4: While holding the base cover and weighted insert with one hand, connect the pole to the base, sliding the locking lever into the bottom of the pole with your other hand. STEP 5: Turn the L-shaped locking lever clockwise to securely attach the pole to the base. STEP 6: Set the base on the floor, weight side down. Push the pole ring down until it sits directly on the base. Fan Head Assembly: You are now ready to assemble the fan head. STEP 1: Position the rear grill over the motor shaft, making certain the notches at the top and bottom of the rear grill fit over the prongs on the motor housing. Please make sure the rear grill fits securely against the motor housing. STEP 2: Secure the rear grill in its place using the rear grill mounting nut. Turn this nut clockwise and tighten firmly. STEP 3: Slide the fan blade, with the hollowed interior of the blade facing toward the rear grill, firmly onto the motor shaft. The top of the motor shaft should lie even with the center of the fan blade. STEP 4: Now use the securing screw to lock the blade into place. Tighten the screw into the side hole of the fan blade, against the motor shaft, until both the blade and screw are secure. STEP 5: Center the front grill by aligning the Holmes logo on the logo plate so it is horizontal and parallel with the floor. Then, holding the front grill against the rear grill, push the black grill ring into place at the top and bottom of the fan. (Push directly on the black grill ring, not on the grills themselves. ) Finish securing the grill ring in the same manner until both grills are joined underneath the black ring. Final Assembly: First, slide the inner pole extension up from the outer pole. Insert the pole locking knob into the hole on the outer pole, to securely hold this position. [. . . ] STEP 2: Clean the fan blade, front and rear grills with a soft, moist cloth. STEP 3: Replace blade, tighten screw, and securely fasten the front grill. For short term or seasonal storage of your Holmes fan EXTEND THE LIFE OF YOUR FAN Fan Head, Base, and Pole Cleaning: Using a soft, moist cloth, with or without a mild, soap solution, carefully clean the fan base, pole, and head. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water. FAN BONNET FAN STORAGE: Your fan can be stored in the off-season either partially disassembled or assembled. [. . . ]