User manual HOLMES HASF1750RC

[. . . ] 8) DO NOT operate any appliance with a damaged cord or plug, if motor fan fails to rotate, after the appliance malfunctions, or if it has been dropped or damaged in any manner. Return appliance to manufacturer for examination, electrical or mechanical adjustment, or repair. 9) DO NOT operate in the presence of explosive and/or flammable fumes. 10) Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. [. . . ] · Do not allow water to drip on or into the fan motor housing. · Do not use any of the following as a cleaner: gasoline, thinner, benzine (See instructions for fan head assembly) Step 1: To access the fan blade, remove the front grill and the fan blade nut. Step 2: Clean the fan blade, both front and rear grills with a soft cloth moistened with a mild soap solution. Step 3: Replace blade, tighten the fan blade nut, and securely fasten the front grill. FAN STORAGE Your fan can be stored in the off-season either partially disassembled or assembled. It is important to keep it in a safe, dry location. · If stored disassembled, we recommend using the original (or appropriately sized) box. · If stored assembled or partially assembled, remember to protect the fan head from dust. H A B C D E F G J ASSEMBLY INSTRUCTIONS: I K L M N Base / Pole Assembly Step 1: Insert the lower pole (longer of the 2 poles) through the base cover and twist the pole clockwise to lock in position. Be careful to align the cut-away grooves on the threaded joint (male end) with the two protruding raised pieces inside the hollow end of the base cover. Step 2: Turn the base cover upside down (with the lower pole facing the floor) and place the weighted insert into the base cover. The pole threads will be exposed as they protrude through the insert. NOTE: HOLD THE POLE, BASE COVER AND WEIGHTED INSERT IN ONE HAND WHILE TIGHTENING THE BASE NUT WITH THE OTHER HAND. Step 3: Place the base nut on the threaded section and hand-tighten the base nut to securely fasten the lower extension pole to the base. Step 4: Insert the upper pole (shorter of the two poles) with the threaded joint (male end) into the hollow end of the lower pole (female end), until both poles meet. Be careful to align the cutaway / grooves on the threaded joint (male end) with the two protruding pieces inside the hollow end of the lower pole (female end). Step 5: Turn the upper pole clockwise to lock it securely in place. FIGURE 1 A. Logo Plate Front Grill Grill Caps Fan Blade Cap Fan Blade Rear Grill Mounting-ring G. Weight Nut O P Q Fan Head Assembly Step 1: Position the rear grill over the motor shaft, making certain the 2 notches at the top and bottom of the rear grill fit over the 2 protruding notches on the motor housing. Please make sure the rear grill fits securely against the motor housing. Step 2: Fasten the rear grill in place using the rear grill mounting-ring. Turn the ring clockwise and tighten firmly. Step 3: Slide the fan blade; with the hollowed interior of the fan blade facing toward the rear grill firmly onto the motor shaft. Make sure that the motor shaft protrudes from the front of the blade. [. . . ] If you have any problem with this product, please write our Consumer Service Dept. IMPORTANT Return INSTRUCTIONS Your warranty depends on your following these instructions if you are returning the unit more than 30 days after the date of purchase: 1. Carefully pack the item in its original carton or other suitable box to avoid damage in shipping. Before packing your unit for return; be sure to enclose: a) your name, full address with zip code and telephone number, b) a dated sales receipt or PROOF OF PURCHASE, c) your $10. 00 check for return packaging, and d) The model number of the unit and the problem you are having. [. . . ]