User manual HOLMES HASF2219

[. . . ] · To disconnect, grip plug and pull from wall outlet. · Always use on a dry, level surface. · Do not operate without fan grills properly in place. · This product is intended for household use ONLY and not for commercial or industrial applications. PLEASE READ AND SAVE THESE INSTRUCTIONS WARNING: To reduce the risk of fire or electrical shock, DO NOT USE THIS FAN with any SOLID STATE Fan Speed Control Device THIS PRODUCT IS EQUIPPED WITH A POLARIZED A. C. [. . . ] STEP 2: Clean the fan blade, front and rear grills with a soft, moist cloth. STEP 3: Replace blade, tighten blade cap, and securely fasten the front grill. Fan Post Screw Screw Hole Fan Head, Base, and Pole Cleaning: Extension Pole Using a soft, moist cloth, with or without a mild, soap solution, carefully clean the fan base, pole, and head. Please use caution around the motor housing area. Do not allow the motor or other electrical components to be exposed to water. NOTE: If your fan does not have a screw hole in the extension pole but instead has an indentation around the top of the pole; please do the following: Step 1: First, place the fan head assembly onto the extension pole and tighten the fan post screw until a secure fit is obtained. Step 2: Insert the tilt adjustment knob into the neck joint and tighten in place. FAN STORAGE: Your fan can be stored in the off-season either partially disassembled or assembled. It is important to keep it in a safe, dry location. · If stored disassembled, we recommend using the original (or appropriately sized) box. · If stored assembled or partially assembled, remember to protect the fan head from dust. The exclusive Holmes Products FanBonnet is available to protect your fan. OPERATING INSTRUCTIONS: Step 1: Set fan base on a dry, level surface. Step 2: Plug cord into any standard 120 volt AC outlet. Please make sure the Selector (Speed) Control is in the Off position. Selector (Speed) Control is located on the top of the Fan Motor Housing. Step 3: The SPEED is adjusted by turning the control knob to the desired setting, Off-High-Med-Low. Step 4: The OSCILLATION Control knob is located on the top of the Fan Motor Housing. To Start Oscillation, Push Control knob down. To Stop Oscillation, Pull Control knob up. ADJUSTMENT INSTRUCTIONS: Tilt Adjustment: Follow these instructions to tilt the Fan Head for upward angle air movement. STEP 1: To change the tilting angle of the fan head, simply loosen the Tilt Adjustment Knob (see fig. 4). STEP 2: Move the fan head to the desired angle, then firmly tighten the knob to lock in place. Height Adjustment: Follow these instructions to adjust the height of the fan. STEP 1: Turn the extension pole base collar (see figure 3 and 5 on Page 2) counter-clockwise to loosen pole. STEP 2: Adjust the pole to the desired height, and firmly tighten collar in a clockwise direction. CLEANING/MAINTENANCE INSTRUCTIONS: Follow these instructions to correctly and safely care for your Holmes Products© stand fan. Please remember: · Always unplug the fan before cleaning or disassembling. · Do not allow water to drip on or into the fan motor housing. [. . . ] 2. Before packing your unit for return; be sure to enclose: a) your name, full address with zip code and telephone number, b) a dated sales receipt or PROOF OF PURCHASE, c) your $15. 00 check for return shipping and handling, and d) the model number of the unit and the problem you are having. (Enclose in an envelope and tape directly to the unit before the box is sealed. ) 3. Holmes recommends you ship the package U. P. S. All shipping charges must be prepaid by you (as noted in paragraph F). [. . . ]