User manual HOLMES HFH2986

[. . . ] JCS, at its option, will repair or replace this product or any component of the product found to be defective during the warranty period. Replacement will be made with a new or remanufactured product or component. If the product is no longer available, replacement may be made with a similar product of equal or greater value. Do NOT attempt to repair or adjust any electrical or mechanical functions on this product. [. . . ] DO NOT cover cord with throw rugs, runners, or the like. Arrange cord away from traffic area and where it will not be tripped over. This heater is not intended for use in bathrooms, laundry areas and similar indoor location. NEVER locate heater where it may fall into a bathtub or other water container. Extreme caution is necessary when any heater is used by, or near children or invalids, and whenever the heater is left operating and unattended. Always unplug the heater when not in use. When unplugging, be sure to pull by the plug and not the cord. DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater. DO NOT operate heater with a damaged cord or plug, or after the heater malfunctions, has been dropped or damaged in any manner. Return appliance to manufacturer for examination, electrical or mechanical adjustment, or repair. A heater has hot and arcing or sparking parts inside. DO NOT use it in areas where gasoline, paint, or flammable liquids are used or stored. Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by the manufacturer cause hazards. To prevent a possible fire, DO NOT block air intakes or exhaust in any manner. DO NOT use on soft surfaces, like a bed, where openings may become blocked. To disconnect heater, turn controls to OFF, then remove plug from outlet. Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord shall be No. 14 AWG minimum size and rated not less than 1875 watts. If the heater will not operate, see specific instructions on Auto Safety Shut-off. F E AT U R E S - O P E R AT I O N S 18. [. . . ] When the ambient temperature drops below the · After cleaning, be sure to completely dry the heater set temperature, the heater will turn on automatically. NOTE: When the 1Touch® thermostat is set, either the HIGH · Store your heater in its original carton in a cool, dry or LOW power light, and the set temperature light will location. (See Figure 1 and 2) 1TOUCH® THERMOSTAT INSTRUCTIONS D D A TROUBLESHOOTING Figure 2 A. 1Touch® Mode/Off Button Temperature Set Lights D HI/LO Power Lights Power Light B If your heater fails to operate, unplug the heater and: · Make sure the electrical outlet and circuit breaker are working. [. . . ]