User manual HOLMES HFH506TG

[. . . ] 7) Always unplug the heater when not in use. 8) When unplugging, be sure to pull by the plug and not the cord. 9) DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater. 10)DO NOT operate heater with a damaged cord or plug, or after the heater malfunctions, has been damaged in any manner. [. . . ] This plug will fit into the power outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact qualified personnel to install the proper outlet. DO NOT DEFEAT THE SAFETY PURPOSE OF THIS POLARIZED PLUG IN ANY WAY. 1. For heater operation, please set the Thermostat all the way to HI. Turn the Mode Control to desired heat setting (LO for 500W, MED for 1000W, or HI for 1500W). For fan-only operation, without any heat output, turn the Mode Control to the FAN setting. The Power Light will remain lit during operation. SETTING THE THERMOSTAT 1. You need to set thermostat on HI to start heater (See fig. Allow heater to operate and warm up the room. When the desired temperature/comfort level is reached, lower the thermostat setting until the heater stops operating. The control will now automatically maintain the pre-set temperature level by turning the heater ON and OFF. Note: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the thermostat setting. ILLUSTRATIONS Figure 1 OFF FAN LO (500W) MED (1000W) CLEANING/MAINTENANCE During Season Care: 1. Always unplug the heater before cleaning. Clean the unit with a soft cloth moistened with a mild soap solution. NEVER use abrasive or flammable solvents to clean the unit. After cleaning, be sure to completely dry the unit with a cloth or towel. THERMOSTAT HI (1500W) MODE CONTROL SWIVEL BASE After Season Care: 1. Holmes recommends that you store the unit in its original carton. TROUBLESHOOTING If your heater fails to operate: · UNPLUG THE UNIT · Make sure the electrical outlet or circuit breaker is working. If you find an obstruction turn the heater OFF, and unplug the unit. Carefully remove the obstruction and follow the reset instructions. · The temperature may be set too low. [. . . ] Carefully pack the item in its original carton or other suitable box to avoid damage in shipping. Before packing your unit for return; be sure to enclose: a) Your name, full address with zip code and telephone number, b) A dated sales receipt or PROOF OF PURCHASE, c) Tour $7. 00 check for return shipping and handling, and d) The model number of the unit and the problem you are having. (Enclose in an envelope and tape directly to the unit before the box is sealed. ) 3. Holmes recommends you ship the package UPS ground service for tracking purposes. [. . . ]