User manual HOLMES HFH680

[. . . ] This Warranty applies only to the original purchaser of this product. This Warranty applies ONLY to repair or replacement of any supplied or manufactured parts of this product that, upon inspection by The Holmes Group, Inc. , authorized personnel, proves to have failed in normal use due to defects in material or workmanship. The Holmes Group will determine whether to repair or replace the unit. This Warranty does not apply to installation expenses. [. . . ] DO NOT use it in areas where gasoline, paint, or flammable liquids are used or stored. Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by The Holmes Group may cause hazards. To prevent a possible fire, DO NOT block air intakes or exhaust in any manner. DO NOT use on soft surfaces, like a bed, where openings may become blocked. To disconnect heater, turn controls to OFF, then remove plug from outlet. Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord shall be No. 14 AWG minimum size and rated not less than 1875 watts. If the heater will not operate, see specific instructions on Auto Safety Shut-off. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. The inside of the unit contains no user serviceable parts. All servicing should be performed by qualified personnel only. Discontinue use if plug or outlet is hot. Recommend outlet be replaced if plug or outlet is hot to touch. F E AT U R E S - O P E R AT I O N S PRE-OPERATING INSTRUCTIONS 1. Carefully remove your heater from the box. (please save the carton for off-season storage). Attach carry handle with provided thumb screws. Please be sure to tighten firmly (See fig. Make sure the unit is in the OFF position before plugging the heater into the outlet. Avoid overloading your circuit by not using other high wattage appliances in the same outlet. [. . . ] The control will now automatically maintain the pre-set temperature level by turning the heater ON and OFF. NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the temperature setting. Figure 1 Figure 2 E D A. Carry Handle Figure 3 CONTROL PANEL CLOSE-UP THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC (Alternating Current) PLUG (a plug having one blade wider than the other). [. . . ]