User manual HOLMES HOH2501TG

[. . . ] Extreme caution is necessary when any heater is used by, or near children or invalids, and whenever the heater is left operating and unattended. Always unplug the heater when not in use. When unplugging, be sure to pull by the plug and not the cord. DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater. [. . . ] You may hear a gurgling sound as the liquid settles. (The control panel will be closest to the floor). Place the "U" bolt over the last joint of the heater with the threaded ends pointed upward. Align the holes in the axle with the "U" bolt and slide into place. Secure the axle with the two provided wing nuts. While the unit is still upside down, take the front foot, and snap it into the corresponding holes in the front part of the heater. This front foot is not meant to be removed once it is attached to the bottom of the unit. NOTE: This unit can not be operated without wheels and front foot assembled. OPERATING INSTRUCTIONS 1. The power light will illuminate and remain lit when the heater is on. For heater operation, set the Thermostat control all the way to HI. Turn the Heat Setting Control to desired heat setting (LOW for 600W, MED for 900W, or HIGH for 1500W). ILLUSTRATIONS Carry Handle SETTING THE THERMOSTAT 1. Set the Thermostat control all the way to HI. When the desired temperature/comfort level is reached, lower the thermostat control setting until the heater stops operating. The control will now automatically maintain the pre-set temperature level by turning the heater ON and OFF. Note: The Power light will remain lit during operation. Note: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the thermostat setting. Cord Wrap Figure 1 Carry Handle Thermostat OFF I Lo 600W II Med 900W III Hi 1500W Easy Roll Wheels CLEANING/MAINTENANCE During Season Care: 1. Always unplug the heater before cleaning 2. Please be very cautious near the metal fins. NEVER use abrasive or flammable solvents to clean the unit. After cleaning, be sure to completely dry the unit with a cloth or towel. Holmes recommends that you store the unit in its original carton. Power Light Figure 2 MODE Control TROUBLESHOOTING If your heater fails to operate: · UNPLUG THE UNIT · Make sure the electrical outlet or circuit breaker is working. [. . . ] Carefully pack the item in its original carton or other suitable box to avoid damage in shipping. Before packing your unit for return; be sure to enclose: a) Your name, full address with zip code and telephone number, b) A dated sales receipt or PROOF OF PURCHASE, c) Your $10. 00 check for return shipping and handling, and d) The model number of the unit and the problem you are having. (Enclose in an envelope and tape directly to the unit before the box is sealed. ) 3. Holmes recommends you ship the package UPS ground service for tracking purposes. [. . . ]