User manual HOLMES HRH721

[. . . ] 7) Always unplug the heater when not in use. 8) When unplugging, be sure to pull by the plug and not the cord. 9) DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater. 10) DO NOT operate heater with a damaged cord or plug, or after the heater malfunctions, has been damaged in any manner. [. . . ] At 1500 Watts, this unit draws 12. 5 Amps. OPERATING INSTRUCTIONS 1. For heater operation, please set the Thermostat all the way to HI. Turn the Selector Control to desired heat setting (LO for 1000W or HI for 1500W). The Power Light will remain lit during operation. SETTING THE THERMOSTAT 1. You need to set thermostat on HI to start heater (See fig. Allow heater to operate and warm up the room. When the desired temperature/comfort level is reached, lower the thermostat setting until the heater stops operating. The control will now automatically maintain the pre-set temperature level by turning the heater ON and OFF. The Temperature Range Display can be used as guidance, but will not provide exact measurement. Note: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the thermostat setting. ASSEMBLY INSTRUCTIONS There are 4 casters and 4 screws provided within the packaging that you will need to assemble the base. Note: Casters are not necessary for the unit to run properly. If you wish to install without castors skip to number 5. Carefully remove the base and 4 castors from the box. Turn the base upside down and screw the castors into the 4 corresponding holes. Place the base right side up on a firm level surface. Carefully remove the flat panel heater from the box. With the grill facing you, place the tabs at the bottom of the heater directly into the corresponding holes in the base and slide the heater to the left. To remove the heater from the base, press down on the lock switch located on the right side of the base and slide the heater to the right and lift up. CLEANING/MAINTENANCE During Season Care: 1. Always unplug the heater before cleaning. Clean the unit with a soft cloth moistened with a mild soap solution. NEVER use abrasive or flammable solvents to clean the unit. [. . . ] Carefully pack the item in its original carton or other suitable box to avoid damage in shipping. Before packing your unit for return; be sure to enclose: a) Your name, full address with zip code and telephone number, b) A dated sales receipt or PROOF OF PURCHASE, c) Your $10. 00 check for return packaging, and d) The model number of the unit and the problem you are having. (Enclose in an envelope and tape directly to the unit before the box is sealed. ) 3. Holmes recommends you insure the package (as damage in shipment is not covered by your warranty). [. . . ]