User manual HOLMES HS4600

[. . . ] Extreme caution is necessary when any heater is used by, or near children or invalids, and whenever the heater is left operating and unattended. Always unplug the heater when not in use. When unplugging, be sure to pull by the plug and not the cord. DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater. [. . . ] Lastly, line up the screw hole on the Base Tube with the opening on the tubing attached to the heater's housing and insert the Tilt Adjustment Knob. Make sure the heater is in an upright position and tighten the Tilt Adjustment Knob. Make sure the unit is in the OFF position before plugging the heater into the outlet. NOTE: Avoid overloading your circuit by not using other high wattage appliances in the same outlet. At 1500 Watts, this unit draws 12. 5 Amps. OPERATING INSTRUCTIONS: 1. For heater operation, please set the Thermostat all the way to HI. Turn the Selector Control to desired heat setting (LOW for 1000W or HI for 1500W). For fan-only operation, without any heat output, turn the Selector Control to the FAN setting. NOTE: The Power Light will remain lit as long as the unit is plugged in . THERMOSTAT INSTRUCTIONS: Setting the Thermostat: 1. Before setting the thermostat, allow heater to operate and warm up the room. You need to set thermostat on HI to start heater (See fig. When the desired temperature/ comfort level is reached, lower the thermostat setting until the fan/heater stops operating. The control will now automatically maintain the pre-set temperature level by turning the heater ON and OFF. NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the thermostat setting. THIS PRODUCT IS EQUIPPED WITH A 3-PRONG PLUG Make sure the electrical receptacle is of the configuration and capacity appropriate for the heater (see below). An adapter as shown in (fig. C) is available in most hardware stores for connecting three bladed grounding type plugs to two slot receptacles. The green grounding lug must be connected to a permanent ground such as a properly grounded outlet box, as shown in (fig. B). The adapter should not be used if a three slot grounded receptacle is available. ADJUSTABLE-TILT INSTRUCTIONS: 1. Carefully adjust the unit to direct the heat flow. To adjust the tilt angle of your heater, first loosen the Tilt Adjustment Knob. Then simply adjust the heater to the desired angle and re-tighten theTilt Adjustment Knob. CAUTION: FRONT GRILL IS HOT WHEN UNIT IS IN OPERATION Figure 1 B A C D E A. C) CLEANING/MAINTENANCE INSTRUCTIONS: During Season Care: 1. [. . . ] Operating this unit under conditions other than those recommended or at voltages other than the voltage indicated on the unit, or attempting to service or modify the unit, will render this WARRANTY VOID. Unless otherwise proscribed by law, Holmes shall not be liable for any personal injury, property or any incidental or consequential damages of any kind. SOME STATES DO NOT ALLOW THE EXCLUSION F. All parts of this Holmes product are guaranteed for a period of 5 years as follows: a. [. . . ]