User manual HOLMES HS7000

[. . . ] HS7000 TM TM Flat Panel H EATER OWNER'S GUIDE PLEASE READ AND SAVE THESE INSTRUCTIONS Page1 PLEASE READ AND SAVE THESE IMPORTANT SAFEGUARDS When using electrical appliances, basic precautions should always be taken to reduce the risk of fire, electric shock, and injury to persons, including the following: 1) Read all instructions before using the appliance. 2) To avoid fire or shock hazard, plug the appliance directly into a 120 V AC electrical outlet. To avoid burns, DO NOT let bare skin touch hot surfaces. If provided, use handles when moving this heater. [. . . ] Place the base (with the tab on the left) on what now is the top of the heater directly onto the corresponding locators and slide the base to the left. This will secure the unit and the base together. To remove the heater from the base, turn the heater upside down (with the grill facing you), and slide the base to the right and lift it up. Page2 WALL MOUNTING INSTRUCTIONS: CAUTION: PLEASE MAKE SURE THE HEATER IS UNPLUGGED AND COOLED DOWN TO ROOM TEMPERATURE BEFORE WALL MOUNTING THIS UNIT. This unit has the unique feature of using the base as the wall mount bracket. (Wall mounting hardware is not supplied. ) Refer to Figure 2. To install the heater on the wall, follow these easy steps: Note: If your unit has casters attached, you'll need to remove them. If the base is still attached to the bottom of the heater, you'll need to remove it (follow step 5 in assembly instructions). Select a location on the wall where you would like to have the heater mounted. Use the base as a template for hole locations 3. Use appropriate hardware for different mounting surfaces (see below). Selected hardware must be able to support a minimum of twenty-pound weight. When securing the base/wall mount to the wall, keep the lock tab to your left. Once the base/wall mount is in place, align the mounting tabs on the back of the heater with the holes in the base/wall mount and slide the heater to the right until it stops and is secure. To remove the heater, simply slide it to the left. NOTE: This unit is not to be mounted in ways other than shown in Figure 2. There are many ways to attach your heater to vertical walls if desired. Please, use the applicable section of this manual to safely install your heater. OPERATING INSTRUCTIONS: 1. Unless wall mounted, place heater on a firm level floor surface. For heater operation, please set the Thermostat all the way to HI. Turn the Selector Control to desired heat setting (LO for 750W or HI for 1500W). The Power Light will remain lit during operation Note: This unit does not have a fan. [. . . ] This Warranty applies only to the original purchaser of this product. This Warranty applies ONLY to repair or replacement of any supplied or manufactured parts of this product that, upon inspection by Holmes authorized personnel, proves to have failed in normal use due to defects in material or workmanship. Holmes will determine whether to repair or replace the unit. This Warranty does not apply to installation expenses. [. . . ]